Kundeanmeldelser for VEVOR gjæringsmål, standard spor 19 x 10 mm, saganlegg av aluminiumslegering med 46 cm rutenett, 15 vinkelstopp, stempel og avtakbar skive, for trebearbeiding

Der Anschlag funktioniert soweit gut. Einzig die definierten Einrastpunkte sind schwer zu treffen. Bei mir rutscht der Federbolzen grundsätzlich an den Löchern vorbei und es is ein ziemliches Gefrickel, die richtige Position zu finden.

Reçu dans les délais , outil simple d'une réalisation soignée , emballage très protecteur . Matériel léger destiné à une utilisation amateur mais qui peut durer dans le temps si on est soigneux . Rapport qualité/prix intéressant . ( malheureusement fabriqué en Chine ) . Nécessité de fraiser le guide pour l'adapter à la fente de ma table de scie Lurem mais ce n'était pas une surprise . Précision et fiabilité à voir dans le temps .

Atrezzo molto ben fatto molto preciso e semplice da utilizzare. Arrivato in una confezione molto protettiva. In base al mio utilizzo (hobbystico) lo consiglio

thought I bought the one with the extention

A bit sloppy in my t-track but after some adjusting it was perfect

Nice unit and well built. Accurate straight from factory. My stopper had some machining issues but I quickly received a replacement so I can say that the customer service works very well too. The red indicator of the stopper could be better. I switched it to other side of the stopper hinge to get the gauge away from blade. The t-rail bar should be replaced with one that has eccentric tightening mechanism. The current one is annoying to adjust, needs a lot of threadlock to stay tight and those little ball bearings clog by saw dust. The tension spring in them is so soft that they also need to be basically tensioned until the ball cup scratches the t slot.

Came out of the box as square as any of my current squares allow me to measure… could use a longer miter bar as it gets a little squirrelly near the front of the saw, keeping in mind that my saw doesn’t allow me to use the stabilizer disc underneath the bar… slot is too narrow. Will try to find a smaller disc to use and see if that helps. Micro-adjustment assembly is nice. Extension wing is helpful but has a bit too much play in it at full extension. Overall better quality than expected for the price point.

Not the size for what I Needed it doesn't really fit my power saw table.

Nice tool, high quality material, and sturdy, fit miter slot. I would like two issues, that need improvement 1. needs to have a UHMW tape attached to the bottom of the aluminum bar, to slide smoothly. 2. to be parallel to the table, you need to place a washer between the part that goes into the miter slot and the top sliding part. I used it on a router table to cut 3/4" slot for T-Slot channel, in large plywood board. using it I could support the plywood that was longer than the size of the edge of the table.

Die Einstellung der Schiene mit seitlichen Schrauben ist nicht mehr Zeitgemäß und umständlich! Da sollte man alles von oben wie bei anderen Herstellern einstellen können. Produkt ist aber soweit o.k.