Kundeanmeldelser for VEVOR gjæringsmål, standard spor 19 x 10 mm, aluminiumslegering med 48–89 cm indeksering, 15 vinkelstopp, justerbart stempel og avtakbar skive, for trebearbeiding

the size and weight of the unit becomes a problem with smaller table saws like dewalt, the T-slot rail is not stable enough to hold the unit and only locks (with coin) in the front creating a lot of play at the end of cuts. I will likely build a infeed and outfeed support to hold it more steady

The item is reasonable, but I found it cheaper on another website after buying it here; it should always be cheaper on the original website.

An sich ein guter Anschlag. Auch die Materialien sind gut. Ein großes Manko ist der fehlende zweite Führungsring in der T-Nutschiene. So kann der Anschlag selbst leicht ausgehebelt werden, das kann kann zu Beschädigungen oder auch gefährlich sein. Ich werde den Anschlag selbst adaptieren um ihn dann einwandfrei nutzen zu können.

It fit my saw but i want It on the right side of the blade and I cant flip It around so the measument is matching so for me this is not turned out as a great buy, its been stored under the table ever since buying 😑

It wouldn't fit in my miter slot. I checked the slot with calipers and it's perfect. I checked the miter and it varies from front to back. It's an easy fix but for the price, it shouldn't be necessary.

I bought the vevor mitre gauge based on reviews I saw on utube. The price was good and it looked perfect as an upgrade for me. I break stick down on my table saw and all the reviews showed the mitre gauge with an extendable base. You can guess my dissaponting when it arrived with no extendable base. The illustrations of the gauge all show the flip stop obscuring the end of the gauge so covering up the view of any extension I wonder if this is deliberate. The fence as delivered dies the jib but nothing more.

I did not receive this order. I received a message that it was damaged in shipping and returned to shipper. The tracking shows that it was returned to shipper.

Pushing a longer board it is way too easy to override the spring pressure of the balls and springs, that keep it t tensioned in the slot. It's hard not to deflect a couple of degrees as you push it. Basically if you need the fence your board is too long for this miter gauge, you will deflect the angle and get an inaccurate cut. When I first set it up using a five cut method on a 12" piece of plywood. It wound up at an almost perfect .oo2" on the last cut, right out of the box. As soon as I cut a 6" board 30" long, the cut was about . 020 out of square. Huge waste of money! Find a better miter gauge that doesn't use springs. This might work if you were only cutting short pieces for a segmented ring. Other than that it's junk for standard use. P.S. The problem was not my saw top. It shined up, smooth and very slick. I even made a conscious effort to try and keep it from twisting by trying to counteract the twist as it made the cut. It helps but it's impossible to do repeatedly. Please find one that does not use springs for tension.

Never received item. Vevor camcelled order waiting on refund.

This thing flexes too much, i dont trust it as square