Kundeanmeldelser for VEVOR gjæringsmål, standard spor 19 x 10 mm, aluminiumslegering med 48–89 cm indeksering, 15 vinkelstopp, justerbart stempel og avtakbar skive, for trebearbeiding

A bit sloppy in my t-track but after some adjusting it was perfect

Nice unit and well built. Accurate straight from factory. My stopper had some machining issues but I quickly received a replacement so I can say that the customer service works very well too. The red indicator of the stopper could be better. I switched it to other side of the stopper hinge to get the gauge away from blade. The t-rail bar should be replaced with one that has eccentric tightening mechanism. The current one is annoying to adjust, needs a lot of threadlock to stay tight and those little ball bearings clog by saw dust. The tension spring in them is so soft that they also need to be basically tensioned until the ball cup scratches the t slot.

Came out of the box as square as any of my current squares allow me to measure… could use a longer miter bar as it gets a little squirrelly near the front of the saw, keeping in mind that my saw doesn’t allow me to use the stabilizer disc underneath the bar… slot is too narrow. Will try to find a smaller disc to use and see if that helps. Micro-adjustment assembly is nice. Extension wing is helpful but has a bit too much play in it at full extension. Overall better quality than expected for the price point.

Not the size for what I Needed it doesn't really fit my power saw table.

Die Einstellung der Schiene mit seitlichen Schrauben ist nicht mehr Zeitgemäß und umständlich! Da sollte man alles von oben wie bei anderen Herstellern einstellen können. Produkt ist aber soweit o.k.

Välbyggd, andas kvalitet till ett bra pris. Har kapat flertalet goner med bra resultat Rekommenderas starkt.

I bought this a while ago and have been waiting to get my table saw set up properly and I finally got it together a few weeks ago and the miter gauge was really good for the price . Beats the factory one that came with the saw.

Great addition to my table saw. Better than the one that came with the saw. For the price, you can't go wrong.

The Miter Gauge is really precise and simple to set up. The only thing I'd like if it had a possibility to have support for wider stock to be held up by something when you extend it and perhaps to have something at the bottom of the fence so that it would not glide on the table saw metal on metal but rather some kind of softer material that would not damage the table saw surface.

Very solid build. Assembly quality and precision are generally very good, some minor misalignment's here and there, within 0.2 degree precision, but at extreme angles expect 0.4 degrees, I bought 3 sets, there are slight variations between them. On a fine tuned saw you can expect very high quality results with this Vevor miter gauge. The grater is extendable up to 35"/890mm that's very impressive. Simple repeatable cuts with the built in stop, which has micro adjustment. It can be difficult to read the millimeter measurement as it is partly hidden by the pointer, Inches are easy to read though. The pivoting screw in the angle meter, has a slight wiggle 0.1 degree, its as good as it gets with the design used. I would buy again.