Kundeanmeldelser for VEVOR gjæringsmål, standard spor 19 x 10 mm, aluminiumslegering med 48–89 cm indeksering, 15 vinkelstopp, justerbart stempel og avtakbar skive, for trebearbeiding

Very happy with the product.

Lässt sich sehr gut einstellen und liefert präzise Ergebnisse.

Nice tool, high quality material, and sturdy, fit miter slot. I would like two issues, that need improvement 1. needs to have a UHMW tape attached to the bottom of the aluminum bar, to slide smoothly. 2. to be parallel to the table, you need to place a washer between the part that goes into the miter slot and the top sliding part. I used it on a router table to cut 3/4" slot for T-Slot channel, in large plywood board. using it I could support the plywood that was longer than the size of the edge of the table.

Good quality been using it a lot since day one, worthwhile addition to my table saw. Would recommend it for this price .

Mycket bra och stabil ................................................ .

Ár értékben teljesen megfelelő. Könnyen kezelhető és beállítható áll. Pl. Hikoki asztali fűrészhez is jól működik.

For the price, this is a very good Miter Guage for the DIY'er. The fit into the T-slot was a bit loose, but that was easily corrected by wrapping two strips of painter's tape on the bottom and side of the slide. I've seen much worse fits on more expensive miters.

So far looks great. Set up was almost bang on out of the box! A few minutes of tweaking and it's good to go. It's very solid and should last for some time. To get a miter gauge of this quality and feature set for less than a 100 bucks is outstanding! Happy I made the purchase!