Kundeanmeldelser for VEVOR presisjonsgjæringsmåler, standard spor 19 x 9,5 mm, gjæringsmåler for bordsag i aluminiumslegering med 61 cm gitter, 15 vinkelstopper, justerbar fjærbelastet stempel og avtakbar skive, for trebearbeiding

thought I bought the one with the extention

Nice tool, high quality material, and sturdy, fit miter slot. I would like two issues, that need improvement 1. needs to have a UHMW tape attached to the bottom of the aluminum bar, to slide smoothly. 2. to be parallel to the table, you need to place a washer between the part that goes into the miter slot and the top sliding part. I used it on a router table to cut 3/4" slot for T-Slot channel, in large plywood board. using it I could support the plywood that was longer than the size of the edge of the table.

Ár értékben teljesen megfelelő. Könnyen kezelhető és beállítható áll. Pl. Hikoki asztali fűrészhez is jól működik.

Nullissime et dangereux !! Le guide sensé être rectiligne parfaitement est en fonte d'aluminium de très mauvaise qualité, ni droit ni plat et les vis sans tête en acier sensées rattraper le jeu ont défoncé la rainure de ma scie sur table car le guide s'est coincé dedans !! Les vis sans tête se dévissent !! J'ai du le détruire pour le ressortir !! À ÉVITER ABSOLUMENT Mise à jour : VEVOR m'a intégralement remboursé le produit après échange avec le SAV suite à mon commentaire. Merci à eux.

the size and weight of the unit becomes a problem with smaller table saws like dewalt, the T-slot rail is not stable enough to hold the unit and only locks (with coin) in the front creating a lot of play at the end of cuts. I will likely build a infeed and outfeed support to hold it more steady

It fit my saw but i want It on the right side of the blade and I cant flip It around so the measument is matching so for me this is not turned out as a great buy, its been stored under the table ever since buying 😑

So I was very excited to finally be able to order this after waiting a long time for it to come back into stock. I assembled it and checked it for true, set it up on my table saw to test and lo and behold there's unfixable play (swing) at the central pivot point even when everything is locked down and there is no way to fix it. So, when you're moving a workpiece forward you can easily push it off-square. The play seems to be in the pivot hole for the central pivot screw and locknut which can't be tightened more because it's the pivot. Perhaps I got a lemon but when I contacted Vervor I received NO communication and no attempt to make it right. They shut down my ticket for "not communicating" but I never received ANY communication from Vevor on this after several attempts to contact their customer support. I have been a vocal supporter of them in the past but now I'm very disappointed in Vevor for not making this right. Others have this mitre fence and say it's wonderful but mine is completely useless. I will be happy to update my review if Vevor admits they have made an error and make this right.