Kundeanmeldelser for VEVOR Trykkbeholder Malingsbeholder Spraymaling Trykkbeholder 10 L trykktank, 70 psi Malingspistol Malingsbeholder Φ 24 × 25 cm Spraymaling Trykkbeholder Malingsbeholder Malingspistoler Maling, beis

Got this pot for resins, I have done two bowls with in no issue, quality great, easy to use. Had to take out paint feeder pipe but this was easy. How I removed the pipe:- Removed filter from bottom of pipe and cut a slot in thread with a metal saw at bottom and removed it with a large screwdriver or you can also put 2 bolts on and locked them tight together and then twisted it off. I also changed the intake valve to a car tyre vale (see image) got the part from https://www.thorite.co.uk as I don’t have an air compressor. I use a makita battery tyre pump but have done it with a foot pump and a bicycle pump, takes 2 mins with a cycle pump to get it up to 50 psi.

Compre una camara de presurizado el domingo y hoy a dia martes ya la tengo en casa! Increíble precio por su gran calidad y sobre todo rapido! Todo PERFECTO no soy un BO0T👍🏼👍🏼🔥

I ordered the smaller 10l pressure pot from Vevor. It seems designed for resin casting but still has a paint pipe installed in case you want to spray paint. This gets in the way of casting. I think Vevor should remove it. I did - with an angle grinder. I couldn't unscrew it. The pot works fine up to 50 psi (which is high as I need to go). No bubbles in the resin. No leaks from any point on the pot either, so no need for the supplied sealant. For £114, this pressure pot is way cheaper than the competition. I didn't find any CE quality marks and I haven't tested the safety pressure release (60psi) but it works well. If Vevor supplied castors the price would be a little higher, but I think they could remove the paint pipe (as an option?) or blank off that fitting without a major cost and sell it for the purpose most purchasers will use it for - resin casting. It would be good if they supplied an adjustable caddy as well as the internal base plate. Overall however, I'm very satisfied.

Das Gerät ist super und erfüllt komplett seinen Zweck. Seit ich es benutze habe ich blasenfreies Epoxidharz. Bin begeistert.

Really good pressure pot - using it for resin casting

Easy to adapt, operate and does give a clear resin finish.

Ho comprato questo serbatoio a pressione,ho dovuto comprare in più un tubo binato e una pistola buona per verniciatura a spruzzo a solvente nitro,in più qualche raccordo e niplesnper collegare tutto, provata sul campo va benissimo come una pompa a membrana,si solto regolo la pressione a 1 bar nel serbatoio alla pistola regolo dal compressore circa 4 bar.eccezzionale

This pot is simply ideal for resin casting. So easy and perfect without the slightest of modding. If you're making anything that needs casting, this pot is definitely for you. Don't think too much, it is honestly perfect

Ik heb deze omgebouwd om te gebruiken als drukvat voor epoxy. Systeem is goed dicht. Heb nu een grotere gekocht zodat ik bredere gietsels kan maken.

Easy to use, good quality