Kundeanmeldelser for VEVOR Høytrykksspylerpumpe, 19 mm (3/4") aksel horisontal triplex-stempel, 227 bar (3300 PSI), 9,5 l/min (2,5 GPM), erstatnings høytrykksspylerpumpesett med 5 dyser, kompatibel med Simpson MorFlex 40224, 40225, 40226, Santoprene

Pump mounted perfectly to my pressure washer. Works great.

Its a mean beast. Perfect for cleaning equipment. Recommend this 100%

Exactly as pictured and described. Fast shipping and it works well. Good communication. Happy bout this purchase.

Was sceptical going from a very well known pump to the Vevor. Shipping was 2 days, simple to install. Very heavy duty feeling and seems well made. Used it for about 3 hours since installation and everything is great. Went from a 3700 psi pump to the Vevor 4200 psi. A big difference in the feel of the wand and better cleaning from my surface cleaner. Also, I purchased the 3 year warranty just to be sure.

Adorei o produto. É muito bom

Looks great. Can't wait to try it out.

Works great.

Fit and Worked perfectly. turned a multi year failing pressure washer into something usable.

Montée en lieu et place ! quelques modifications pour les raccordement tuyaux + rajout manomètre Parfaitement fonctionnelle Correspond Parfaitement a mes intentions 😃😇😉 Petite attention au longueur vis btr dans le bloc moteur ( rajout de rondelles)

Bolts right up and pumps fine. I wish they'd use hex head bolts vs socket screws. There's no way to get a dead-on allen key in there so you're left with either cutting a right angle hex key down or making a ball hex make it "good enough." The oil vent cap didn't screw properly and was a tight despite not fully threading down. This allowed water to get into the oil (milky/cloudy appearance). Thankfully, the sight glass is easy to check and I went ahead and changed the oil - I used SAE 30 Non-detergent - it takes approx 5oz of oil. You can verify in the sight glass when it's covering the dot. To change, you can either siphon the oil out or remove the drain bolt on the bottom. I retightened it with slip pliers until the O-ring was snug. I confirmed with a pressure gauge that the pump is preset to ~2500PSI @ open and closed triggers @ ~3100PSI from a 190CC engine. Seems to work a bit better than the cheap vertical engine pumps but I'll update my review soon after an extensive test.