Kundeanmeldelser for VEVOR høytrykksspylerpumpe, 22 mm (7/8") aksel vertikal, 214 bar (3100 PSI), 9,5 l/min (2,5 GPM), reserve høytrykksspylerpumpesett med 5 dyser, kompatibel med Briggs & Stratton, Generac, Devilbiss, Troy Bilt, Honda, Craftsman

So there was a delay in shipping and had to wait for it another additional week delayed my plans and lost some money due to not being able to use my pressure washer. I had to drill the bolt holes out as the diameter was too small for my mounting screws. I also needed spacers which I ended up using a stack of washers for each bolt. They should include spacers but don't. Once I got it all together the threaded pressure couple needed to be tightened it was left loose. All in all it works and wasn't bad for the money. I just hope it keeps working. Time will tell.

Good evening, received a brand new pressure washer pump that came with a broken hose connection. I understand sometimes you will receive items that is not in best condition but, the review is not for the product. The review is for lack of customer service to resolve the defective item and showing no urgency to resolve the issue.

Broke the support on one of the legs installing it... not gonna lie this felt a little cheap too when I pulled it out, gave the pressure washer away and never saw it work.

Installation was straight forward. It started leaking all of its oil out of the top seal after about 20 minutes of use. Then it seized. Would not recommend.

I bought this pump For my craftsman 3200psi washer with a Honda 190 motor …. and it DIDNT line up or fit Just an FYI

This surprised me, for the price and it lined right up where the other one went. Started mounting it, tightening the bolts in a triangle pattern when one of the mounting ears/tabs broke. I emailed Vevor to see if i could return or exchange it. They said they would contact me in 48hrs its been longer. I wish it worked.

Purchased in Nov 2025, attempted to install Feb 2026. Pump assy came packaged well, arrived quickly and looks to be of good quality. However, it will not fit the Briggs and Stratton 675 series engine. Interferes with drain plug boss and aluminum protrusions on the outer edge of motor housing.

Je doute de la pression annoncé, mais dans l'ensemble facile à installer et dépanne correctement.

Doesn't correctly fit craftsman pressure washer. Had to use spacers to offset the pump. Once installed the pump sits lower but works. Not a simple bolt on replacement

Purchased Pressure washer pump from Vevor, it will not fit my unit. My unit has a cable wire running to the carburetor that the Vevor unit does not have. I would like to return it. I have sent pictures of the two units to Venvor. Please send a shipping address to me so I can return the unit.