Kundeanmeldelser for VEVOR Rail Mill Guide System 9 fot Motorsag Frese Rail Guide 4 tverrstangsett

Works as intended. Great price!

I use this rail system for some small scall timber salvage. It is quick and easy to handle by one person. I had a bit of an issue getting the units to level out at the joins but once it was all straightened out is holds level and works great. I don't use the lag bolts that came with it, I made up some leveling and hold down spikes from some 5/16 all thread double nutted through the holes in the cross members. Works better.

Work and looks like the Granberg. I’ve only had two issues so far. First the bolt are by lock and are not supposed to back off but I’ve had one do it. Second I ordered two and there was no plate for attaching the two together and no option to buy a single set. I order the smaller version from Granberg and it’s a little different but works

The length of the individual rails are shorter than the original and that affects the ability to make it straight. Ideally you want one stiff rail, that's easy to get straigth but that is hard to transport. So it's a compromise. This works for shorter lengths like 1-3m but is not ideal for longer lenghts even if you can make that work too. Quality seem to be good. Delivery also worked fine.

Good product for smaller home projects.

I will start by saying that I have used this product a handful of times and it has done its job. I purchased the vevor chainsaw mill as well. It works well, cuts true, but the nuts they use to hold each section together should be locking. The vibrations for the milling process worked a few of the nuts out and have now returned to the forest. Also the toll they give you is similar to your chainsaw tool, but it is made of very weak metal. When tightening the nuts the tool broke.

Works as it should. Takes a bit of fiddling to level. I added parts two kits together to make longer planks without any problems.

Zu gering dimensioniert die Profile. Die Schiene biegt sich insgesamt zu weit durch. Man muss bei einem gebogenen Stamm zu viel unterkeilen.

I have tried making a couple of cuts with it so far and both times the leveling bolts started to blackout as I cut. So as the cut progressed the saw would cut lower and lower and I didn't notice it until the saw couldn't proceed past the backed out adjusting screw. Which I had to screw down further to get past it but by then the slab had a bow cut into it. I going to have to buy some nuts to use as jam nuts to see if I can prevent this from happening again.

Système de guidage assez discutable dans sa stabilité, notamment en version extension par rail 274 cm. Problèmes de dimension des cales de liaison entre modules (trop fine et étroites) n'assurant pas une réelle stabilité d'alignement. Le serrage s'effectue de surcroit avec des écrous papillons très peu efficace. Les tiges filetées servant de piges de réglages de niveau sur la surface de la bille de bois, devrait disposer d'écrou de blocage, car avec les vibrations de la tronçonneuses, elles ont tendance à se dévisser toutes seules et à remonter, faussant la planéité de la planche lors de l'appui (à rajouter absolument). Manque de poids pour plus de stabilité. Produit intéressant dans l'idée, mais à améliorer dans la conception.