Kundeanmeldelser for VEVOR Naglemutterverktøy, 16” Rivnut Verktøysett med 13 STK metriske og SAE-dorer, 186 STK Naglemuttere, M3, M4, 10-24, M5, M6, 1/4-20, 8-32, 5/16-18, M8, 3/101, M-1, M-1, M-1, M-1, M3, M4, 10-24 Bæreveske

Points positifs :Très facile à utiliser, matériel solide et bien conçu, la mallette est pratique, une large gamme d’inserts. Points à améliorer : Notice parfois absente ou non traduite en Français, nécessite parfois de l’espace pour sertir correctement.

Did 3/16 easily . Looking forward to do a 1/4 job that I always worried about before because they were so hard to do.

I have owned a RIVNUT tool previously and this one is of excellent construction Well packaged and solidly built

Works well but the automatic pull bolt rotation tends to get a little stuck from time to time, I think that as you use the rivet nut press more, the sticking will also decrease. The sticking is probably due to the slightly rough machining and when the edges are slightly ground in use, the sticking will also decrease.

Le produit fonctionne bien , malgré un souci au niveau du filage qui est défectueux de l’embout d’appui qui sert a maintenir les mandrins..... C'est embout tourne d'ans le vide , filetage pas aux bonnes dimensions

product worked fine installing 20 - 1/4 rivnuts. after installing three 10-24 rivnuts, the fourth install bent the 10-24 rivnut mandrel. I was 1/2 way through a project...now i'm stuck waiting for a remedy. I would not purchase the semi-auto retraction again. Seems easier to unscrew the mandrel by hand to reduce unnecessary torque on the obviously weak. maybe i got a bad egg? don't know. just want to finish my project that was entirely dependent upon rivnut installation. Uncertain how long it will take to get the replacement part.

Not as heavy duty as advertised. It's a hobbyist piece for lighter work. This is a better tool in the pic

As soon as I got this, I put it to use. The nut serts seem like good enough quality. The crimping tool works great until you try to get it to release. The auto release function is not great. You really have to jack with it to get it release. Problem also with this issue is that when it’s hung up, you can’t take the die out to manually unscrew it. The thing works, but you have to fart with it to go on to the next hole. Aggravation of something so simple as this just upsets you. Side note, I had worse problems with it not releasing with the lager nut serts. The harder you have to press it to compress the nut, the more I had to jack with it to get it to release. The smaller 1/4” serts weren’t as bad, but still aggravating.

Je suis en plein chantier et pressée par le temps, je dois poser une centaine d’écrous à riveter. J'en suis à 8 écrous posés et le filetage M5 a lâché. Chantier totalement à l'arrêt et impossible de trouver la pièce détachée pour la remplacer au plus vite et espérer finir le chantier à temps.

It is not for a weak eighty year old man. I could not close the handles.