Kundeanmeldelser for VEVOR valsemølle 4-i-1 rund flat firkantet halvrund pressevalsemølle, manuelt smykkeverktøy, 0,03-7 mm justerbar tykkelse, stabil og jevn valsing, for duktile metaller, gull, sølv, kobber

My rolling mill works great, the rollers came perfectly level(within .01mm between the highest and lowest spots), only issue it had was the main height adjustment gear came with a bunch of surface rust on it from the factory and needed a good amount of cleaning. everything else was fine though

Does what it says! Recommend 👍💯 1 tip: I'm missing a rubber foot so it doesn't slip.

It’s still going strong for me about a year later. I do this for a hobby, but I use it to make bezel wire, sheet, and use it for wire too and the half round has been nice too. All around good product for the price. Just make sure to keep it oiled so it doesn’t rust. I’ve done copper, brass, and silver with this. So it could for sure handle gold aswell.

Buonissimo prodotto, un piccolo laminatoio ma molto utile ben strutturato e di facile utilizzo, intuitivo. Dispiace che alcuni modelli più grandi non sono commercializzati nel mio paese. Comunque è un laminatoio che risolve le esigenze di utilizzo più richieste. Massimo

Its OK quality, fits very well for silver/gold, for copper/brass rollers are too soft.

Very nice product

I bought this mainly for the half round Works well and was easy to assemble. Good quality for the price

Overall its more than capable of doing what it's designed for. I'm happy with my purchase. The casing around the wheel for up/down handle is made of plastic. In time this will brake, Because of this I give it a 3 out of 5

Haven't unpacked it as we were evicted and would have meant packing it up again. We have been given an extension of six months so will get it unpacked in the near future and give in a whirl. It is quite heavy.

Okey. I am going to be honest. Now i assembled my new Rolling Mill. First expression, having it out from the box, was OK so far so good. Nothing was broken during delivery. I had before this a budget mill also ( from an english company) but it lacked possibility to make round wire, that´s the reason i bought this and the price of course. Very big PLUS was the gear ratio it was easy to roll. The previous mill had not and it was very heavy to roll. Perhaps negative things on this mill was the feeling of cheap and not so accurate cogs. But looking at the mills on Youtube where masters in Asian countries make outstanding jewelry, this mill is not bad, not at all. I couldn´t give 5 stars because of the quality, that is not that bad, don´t get me wrong. I made a peace of sheet and it turned out good, and as i said before, it was easy to roll. I have not tried round wire yet, but i am confident it will be good also. Over all, if you can not afford a expensive mill, i higly recommend this.