Kundeanmeldelser for VEVOR rotasjonsbord for fresemaskiner, 4"/100 mm, horisontal/vertikal modell, presisjonsfresende rotasjonsbord, med 3,1"/80 mm 3-kjevs chuck, M10 T-boltmuttere, for frese-indekseringsverktøy

The rotary table actually looks fine , but when using it vibration during cutting was enough to cause the 3 jaw chuck to rotate no matter how I tried to clamp and stop it rotating. It needs additional clamping and locking facilities.

Pieni pyörittäjä tarkkuus on normi tuote vaatii mittalaitteiston jos haluaa tarkkaa

I unpacked the rotary table and started cleaning it up. I noticed the indicator plate for the table was mounted crooked. After carefully examining it I found a broken off drill or tap ( I couldn't tell which because it was hammered into the casting) under the indicator plate.

Michel de TR en YouTube habla muy bien de ella, por eso la compré, pero sinceramente por sus comentarios me esperaba mas, después de demontarla, cambiar grasa y ajustar, sigue dura en una parte de la vuelta, como si el usillo estuviera algo desviado. Tambien presenta un gran agujero de fundición en el interior del alojamiento donde va el tornillo de avance. No afecta a su funcionamiento pero está. Lo mejor, el precio. Gracias por dar la oportunidad de opinar.

Je déconseille d'acheter ce produit. Le vernier n'est pas juste et ne correspond pas aux angles demandés, rien correspond 😏. De plus quand vous le positionner horizontalement il y a la molette du vernier qui touche le plateau de la fraiseuse. Donc vous êtes obligés de positionner la table rotative sur le côté de la fraiseuse ou le calé en hauteur. Photo jointe. J'ai envoyé un mail à vevor pour

Sehr ungenau

Produs de proasta calitate și vreau sa returnez produsul înapoi dar saitul Vevor nu ma lasă să returnez produsul și nici la mail-ul nu raspund

Tomber en panne à la première utilisation, les pignons ont tenus 5 minutes. Reste la base à réparer avec un vrai entraînement en acier de ma conception.

degree scale on table is off by 20+ degrees in relation to the slots. The scale reads backwards to the rotation. Scale on turning handle is off by 10 min for 1/2 turn. I expected the quality to be low but this is unacceptable. Will you correct this or am i stuck with this junk? As of now i would not buy any thing more from VEVOR. Purchase i made in the past was very good. This is junk unless you replace or make it right.

Degree markets miss aligned, they sent me a new part from China, the screws that held it on were crooked and stripped asking it un removable. Vevor credited me a hundred bucks. I cut off and drilled out fasteners and replaced them with new ones, since the stripped out threads were in the new part. I also added a bearing to the handle tech to make it much smoother.