Kundeanmeldelser for VEVOR rotasjonsbord for fresemaskiner, 4"/100 mm, horisontal/vertikal modell, presisjonsfresende rotasjonsbord, med 3,1"/80 mm 3-kjevs chuck, M10 T-boltmuttere, for frese-indekseringsverktøy

Ottimo prodotto qualità prezzo imbattibile. C'è tuttavia margine per renderlo più preciso riguardando le tolleranze ma fa comunque il suo lavoro. Grazie Vevor.

I bought this for a job, used it then "fixed it". I had to make a 12" dia. disk, then make slots in the disk. I had the worst chatter while turning the handle and cutting. Also seemed to have tight spots. When I finished the job, I took the table apart to see if there was anything I find that would cause this, maybe some backlash or something I could fix. The table works by turning the handle, which drives a worm gear set. The hub of the worm gear is (should have been) bolted to the table top. There are two sets of bolts for this job. What I found was they had counterbored one of the sets too small. So the socket head cap screw would not down the bore. This in turn didn't have enough threads engaged to hold the hub onto the table and they had all backed out or were stripped out. There is 6 of these screws and one of the six didn't even line up and was missing. The other set of holes had a chamfer on the bottom for socket head cap screws, so the bottom of the SHCS made point contact with the chamfer. The fix was to take the right sized end mill and correct the counterbores. To finish, I broke all the edges with a file and stoned the flat surfaces. For the price, some "rework" should be expected. I expected I would have to remove burrs. I didn't expect to have to fix holes. The customer for this table will likely have the skills to rework this table as it comes out of the box.

Nel complesso tutto ok, la qualità è in linea con il prezzo pagato. Spedizione e transazione sempre perfetta

Solid build and rotation accuracy within stated limits, lacks opposing anchor point for use when flat on CNC table - existing slots underneath not rigid enough. Added press fit bearing to worm shaft to reduce excessive play and smoother rotation for CNC coupling.

Fast delivery as ever. The round table comes a llitle bit rough. all edges has to deburred. The slots for positioning keys are a little bit under dimensioned so a dremel tool was needed. My key slots in my milling table is 12mm, but the keys some with 16mm, so I had to get a pair of these else there. Fixing these small issues and you end up with a good round low priced round table.

Thank you

L'axe ou se trouve la manivelle pour faire tourner le plateau est tourdue. Pa simple de la redresser sans risquer de tout casser

Der erste Endruck ist sehr gut, zum arbeiten bin ich noch nicht gekommen aber ich denke er hält was er verspricht.

Very nice rotary table. wish that it had 6 slots to make setups easier. Heavy duty construction with good finish. Only concern is that my initial concentricity checks show a difference when tramming the MT3 hole from the spindle versus putting the indicator on the rotary table and tramming to the spindle. Will have to redo these measurements a few more times to see if indeed the rotary table is not concentric, or if my measurements were not done correctly.

Haven't actually used it but seems fine. Will review again when used