Kundeanmeldelser for VEVOR roterende sveiseposisjoner, 300 kg lastekapasitet, -45° til 90° hellingsvinkel sveiseposisjoner dreiebord, 0,2–2,5 o/min hastighetskontroll, elektrisk og fotpedal, for skjæring, sliping, montering

Zeker Aanrader en snelle levering. Doet wat er verwacht word, afwerking kan beter. Prijs kwaliteit topper.

Put to use and was really easy to use and improved the weld control. So much so we bought 2 x 50kg units recently as well.

Est-il possible d'avoir de mors plus longs sur le mandrin car le serrage de nos pièces n'est pas satisfaisant. ?

Kuvaksen mukainen Hyvin pakattu oli puulaatikossa kaIkki osat mitkä luvattu mukana Rahtiin meni se ylimääräinen 30 no olihan laatikko painava lähes 50kg Käyttötestit seuraa voi olla että joutuu hdastamaan pyöritystä mutta kokeillessa sai sen pyörimään niin hitaasti että juuri eroitti liikkeen jaksaako tuo sitten vääntää kun tulee kuormaa kappale pystöasennossa kyllä mutta miten käy kun kallistaa Jää nähtäväksi

My only complaint is on the packaging. It's not well protected and you can expect at least some minor damage. Mine had the legs tweaked a little and I had to do some work on it to fix it. Also one of the bushings on the acme threaded crank was broken and came out of the housing. I made another one. I had to adjust the hand crank engagement by opening up some holes. No big deal. After a couple of hours of work it was very close to perfect. For the price, no regrets. I recommend it, just be aware it might not be perfect when you get it.

ATTENTION il y a pas de passage central p our par exemple passer un tuyau de gaz pour le chambrage

merci de me transmettre la facture svp https://www.vevor.fr/user/myorder/detail?sn=24082000955714292512

Speed is too high for welding tubes 2.5" or less

I got the 10kg rated positioner, that's probably an accurate estimation of it's capacity. However, it has 2 main problems. Firstly, it's almost unusable with the gear ratio provided, it spins far too fast unless you're welding pencils or something. Luckily, that's a $15 fix by purchasing a 15rpm gearmotor and throwing away the 88rpm one that comes with the unit. Secondly, the chuck is very underrated for this positioner. It's more than a $15 fix, but I had a 5" chuck from an old lathe that I was able to adapt to this, and it suits it much better. So basically, it spins too fast and the chuck is too small. But it's so inexpensive I would still buy it again if I lost this one. One more thing that would be nice is a digital readout on your rpm so you could do repeatable procedures, but not a must-have.

It arrived with a damaged box; it works, but it's dented. I need a replacement and a refund.