Kundeanmeldelser for VEVOR Ambolt Enkelthornet Ambolt 30 kg Stålambolt Smidd Ambolt Robust Hornformet Ambolt Smed Juveler Metallarbeider Smedverktøy Egnet for Nagle, Flating, Smiing og Forming

Städet känns som att det är bra. Tyvärr blev det skadat i transporten, bättre förpackning hade kunnat rädda det.

This anvil works amazing so far. It's well made except the gurdy hole needed to be filed down a bit, same with the edges, but other than that I haven't had any problems at all. I put it on a log, wrapped it up with a chain(bought separately) and started forging. Other than the imperfections, 10/10 beginner anvil!

I use it for knife making. The anvil has really nice rebound with a hammer and a ball bearing test. Overall, I think this is a great purchase. It would make a great starter anvil for someone looking to get started.

This is an awesome starter anvil. Well made, didn’t see any welding beads or anything that indicated imperfections. Did see a small chip along the edge while I was dressing it but it came out with the flapdisk, and well, I was dressing the anvil anyhow! Hardy and pritchel holes are placed correctly too, unlike their other models. The other thing is this thing is considerably larger than its similar counterpart at HF. Has great rebound and SINGS when struck. All in all a great buy for an intro anvil.

Ein für diesen Preis wirklich hervorragender Amboss. Die Verarbeitung ist sehr gut, mit einem Winkelschleifer können die Kanten nach persönlicher Vorliebe gebrochen werden und ich habe auch das Horn vollständig von Farbe befreit (ist aber wohl nicht zwingend nötig). die solide Basis erlaubt eine gute Kontaktfläche mit dem Sockel und bei guter Befestigung kann der Rington fast vollständig behoben werden. Mehrer Projekte und der Amboss zeigt noch keine wirklichen Abnutzungserscheinungen. Das eher tiefe Gewicht ist bei normaler Bedienung (ohne Hilfsperson) überhaupt nicht problematisch. Absolut empfehlenswert!!!

TWO YEAR REVIEW : After having it for some time I'd like to give an honest opinion. My shop specializes in sheet metal fabrication and does forging on the side, both work great. The hardy hole had to be tuned a fair bit with files, this is to be expected it's a piece of cast steel. This means a 0.75" square bar will not fit into it well until you're done cleaning it up. Afterwards it was perfect. The finish could be better in every regard yes and you can (and should!) remove the paint to get that glorious look but all that really matters is the face is flat, has great rebound and is very hard. There is zero reason to purchase an overly priced vintage when something like this exists.

My first anvil . It looks good. Made my first hook. Arrived ih a box that was pretty beat up but anvil was unscathed and ready for work!

little expensive for a hunk of iron

Did the job. Used it to hammer flat and put edges back in pressed metal items. Cheaper and handier than buying a thick block of solid bar.

I like this small anvil. It does what I need as I do not do any heavy anvil work