Kundeanmeldelser for VEVOR Ambolt i støpejern med enkelt horn, 25 kg, tåler kraftige slag, robust rund hornambolt, smeverktøy for gullsmeder og metallarbeidere, smeverktøy og -utstyr

Mine got beaten to hell in shipping. It was sticking out of the side of its all but shattered box when I got it. Some rust and a chipped end, but all of that was almost certainly the delivery folks hating a heavy box. I did find used anvils of higher quality and similar price locally after the fact, and found it at a lower price than on the vevor site later as well so that was a bummer. So maybe shop around a bit. It's perfectly serviceable from my unskilled perspective though. I got it to learn a little smithing so my opinion on quality isn't the most reliable. But by my estimate it tested at about 70 or 80% of the ball bearing bounce height a blindingly expensive anvil produced at literally a tenth of the cost. So I'm still perfectly content and won't ship it back even with its damage it incurred.

Buen producto y buena calidad

Guter Einsteiger Amboss! Macht was er soll!

Great anvil for my jewelry work

Un buen yunque para principiantes, espero que hagan una versión de 70KG del modelo Ingles con el agujero un poco mas pequeño para adquirirlo

package little damage but all good inside

Receive the annual package very well for the cost I was not expecting a whole lot. I knew it would do what I wanted it to do. I was pleasantly surprised to find the hardness very acceptable for the entry price level. I did not check it with the ball bearing, but my 22 ounce ball pan hammer bounces really well. I did knock a little bit down on the quality because the Hardy hole is really not straight. it’s kind of taper, which is really not a problem. I have not found any defects. I’ve only used it two or three times so far and it has held up very well under hot steel while I’m pounding it overall I would give it a 97 because of the price.

I am very pleased with this 110 lb. anvil. Both the Hardy hole and Pritchard holes are correctly sized. The edges are a bit too sharp, but nothing I cannot correct. Great rebound with a 5/8" ball bearing (over 70% rebound). Nice sound on the anvil face when struck with a 2 1/2 lbs. hammer. Overall I opine this anvil to be of a superior value for a DIY hobbyist.

its about as good of a deal on an anvil as you can get for a new one. they ship it free which is insane. it is cast steel so obviously don't leave it to the elements or it will rust.

Bruker denne til produksjon av reparasjons panel til rustsveising av bil. Og har fungert utmerket til det. Anbefales