Kundeanmeldelser for VEVOR festeplate for kompaktlaster, 3/8" monteringsplate for kompaktlaster med 2,28" tilhengerfeste, hurtigfesteplater for laster, kompatibel med Deere, Kubota, Bobcat, Mahindra kompaktlastere, traktor

Had to reinforce the center due to heavy tounge weight on a gooseneck trailer starting to bow the center out. Otherwise great product.

Everything rapidly and well

Rugged and work well used it to mount a 7.5 foot snowplow on my tractor.

This is a heavy built plate, you need to paint it. It comes un-painted and will rust. You can't make this plate for the price that is sold for. Very happy with this purchase.

This 3/8” thick attachment plate with 2x2 receiver is a great value and well built it makes moving trailers and equipment around so much easier.

Overall, it is a good attachment. It is heavy enough and does exactly what someone with a small farm or small acreage would need to use. My only complaint is that it was not painted and did not specify that in description..

Quality is very good, I could not fabricate this for half the price of what I paid. Comes with three quarter inch diameter bolts to mount the hitch plate too, however the mounting hitch can only accommodate 5/16 bolts so no way to attach the hitch plate to the mounting plate without welding it, unless you want to downsize the bolts to 5/16 diameter. Other than that, it fits my John Deere 314 g skid steer perfectly, and is used to move my 28 ft mirage snowmobile trailer loaded with four snowmobiles inside around the property. must be painted before you use it because it is raw steel, unpainted. Good quality product

The Vevor 3/8" receiver hitch plate is very heavy heavy and well constructed. The welds all looked good and the metal finishing was exceptional for the price. The only thing that was somewhat of a surprise is the metal appears to possibly be metal etched to control the rust but was not painted in any way. So this is something that is going to need to be done before bolting the receiver onto the plate and putting it into service. If the plate was going to be used indoors and not exposed to water, the factory etching may have been adequate although it would likely become surface rusted over time (there was surface rust already starting on it when unboxed). Left outdoors, it would likely completely rust up very quickly. I cleaned the surface rust off of it, metal etched & rinsed it again and will paint it with black POR 15 for a heavy duty permanent finish once it dries out.

Much heavier than I expected as in quality and durability.

Seems like pretty good quality, my daughter assembled it quickly and its definitely heavy.