Kundeanmeldelser for VEVOR festeplate for kompaktlaster, 3/8" monteringsplate for kompaktlaster med 2,28" tilhengerfeste, hurtigfesteplater for laster, kompatibel med Deere, Kubota, Bobcat, Mahindra kompaktlastere, traktor

This piece is stout, and perfect for turning my tractor into a small crane. I bought this so I could lift closer to the tractor for mechanical advantage. I welded a chain link to the bottom center and I use a shackle with slings. It works great, and I intend to turn it into a modular attachment adaptor.

This attachment came in a torn up box however there was no damage found upon inspection. The attachment fit very well on my kabota tractor and works well for my needs. One bad thing though, it came bare metal. No paint and already had surface rust. I have not had the chance to prime and paint it so it looks very rusty. But hey it works. I recommend it to anyone that may need this type of attachment.

Works like a champ

Really solid fairly well built not sure about the hardware yet, but have used it several times with no issues really good piece for the price

Everything rapidly and well

Rugged and work well used it to mount a 7.5 foot snowplow on my tractor.

This is a heavy built plate, you need to paint it. It comes un-painted and will rust. You can't make this plate for the price that is sold for. Very happy with this purchase.

This 3/8” thick attachment plate with 2x2 receiver is a great value and well built it makes moving trailers and equipment around so much easier.

Quality is very good, I could not fabricate this for half the price of what I paid. Comes with three quarter inch diameter bolts to mount the hitch plate too, however the mounting hitch can only accommodate 5/16 bolts so no way to attach the hitch plate to the mounting plate without welding it, unless you want to downsize the bolts to 5/16 diameter. Other than that, it fits my John Deere 314 g skid steer perfectly, and is used to move my 28 ft mirage snowmobile trailer loaded with four snowmobiles inside around the property. must be painted before you use it because it is raw steel, unpainted. Good quality product

The Vevor 3/8" receiver hitch plate is very heavy heavy and well constructed. The welds all looked good and the metal finishing was exceptional for the price. The only thing that was somewhat of a surprise is the metal appears to possibly be metal etched to control the rust but was not painted in any way. So this is something that is going to need to be done before bolting the receiver onto the plate and putting it into service. If the plate was going to be used indoors and not exposed to water, the factory etching may have been adequate although it would likely become surface rusted over time (there was surface rust already starting on it when unboxed). Left outdoors, it would likely completely rust up very quickly. I cleaned the surface rust off of it, metal etched & rinsed it again and will paint it with black POR 15 for a heavy duty permanent finish once it dries out.