Kundeanmeldelser for VEVOR Slipevalsemaskin, 610 mm formebredde, metallplate slipevalsebøyemaskin, med 2 avtakbare ruller for lavkarbonstål kobberplate aluminiumslegeringsplate

This came in cover with oil, which is a good thing no rust. My advice if you get one, is to clean it and pull the gear guard and check all gears, found a few lose ones that needed to be tight up. After I got it ready I roll some 20 gauge steel no problem.. As with all these small machines take it slow and don't push it and you can make anything you want. Well that's all folks. Sandman..

The tool, once everything is assembled correctly, works great. I had two issues to deal with however: damage during shipping and an improperly machined pivot retention bolt. The packaging was horrible. The cast iron/pot metal handle came broken in two which turned my new tool into an 85lb pile of junk. Working with customer service was a nightmare and they have no provisions for sending individual parts which meant I would have to re pack and return, not an easy task with a large heavy tool. I ended up repairing the handle myself and was excited to finally use it, only to discover that the pivot bolt on the top that allows the top roller to swing out of the way, was drilled incorrectly, which caused gear misalignment and jamming as I turned the handle. Rather than have to deal with customer service on yet another issue, I disassembled the gearbox and machined a new pivot hole for the retention bolt. The second photo shows the gear box with the cover removed, the pivot bolt is on the top. I was able to disassemble and rotate the square roller sleeve andmachine a new hole for that bolt. After that, the tool works great. Even though VEVOR eventually refunded me $100 for my troubles, I would not buy again and this experience has definitely soured my attitude for anything VEVOR