Kundeanmeldelser for VEVOR Flisekutter 31,5-tommers manuell flisekutter 1,4-tommers fliseskjæremaskin Keramisk porselensflisekutter med laserguide Helstålsramme og ekstra reservehjul Flisekutterhåndverktøy

Corpo di tagliapiastrelle robusto, forte, la guida forte, stabile,,, per il momento soddisfacente ???

robuste excellente machine je la recommande

Pozdravljeni,ali je mogoče kupiti rezervni posodo za olje,ker je tale prispela poškodovana. L.p.Vlado

Mein Mann ist sehr zufrieden mit dem Gerät

Great tile cutter with good features. The laser took a lot of adjustment to get the beam to align with the cutter wheel. The price of the tile cutter sold by Vevor is very competitive for such a well constructed machine. I'd buy this machine again without hesitation.

Tile cutter works well and is great value

It’s kind of a pain to put together but it seems to be a well built cutter for the price. No problems with it so far and I’ve use it on 3 full remodels roughly 700 sq ft of tile.

The tile cutter is a little unstable as delivered, however the addition of a short section of angle iron as a "foot" bolted to each end widened the stance and made all the difference. The second thing I noticed is that the breaker foot can interfere with the cutter wheel scoring the tile with some longer pieces, especially with tile or glass of about 1/4 inch thickness. The cutter was primarily used to cut 8 mm porcelain tile, which it did very well, delivering clean accurate cuts, just don't press too hard when scoring the tile. A deep score seems to cause the to break with a rougher edge. A light score gives a very clean square edge that looks like the factory edge after a little touch up with a 120 grit diamond pad on the rectified 24 inch square tile gloss finish tile. The solution to the problem of cutting thinner materials ( in this case 1/4 inch plate glass mirror) was to replace the lower front bearing of the scoring assembly with a larger diameter bearing of a about 1.5 inch diameter with a bushing on the ID to fit the 8 mm mounting bolt. This bearing rides on the bottom of the guide bar and the larger diameter raises the handle somewhat. However, the result was effortless, accurate cutting of the mirror glass. This had proven impossible to cut and break accurately with the normal hand held glass cutting tools. All in all, I would recommend this, just keep in mind that some tweaking may be necessary, but the basic tool is well worth the money!

Machine de bonne qualité pour un prix très bas. Attention prévoir de l'huile pour machine a coudre pour remplir le réservoir permettant le graissage de la barre de coupe et la roulette. Le laser n'est pas trop utile pour les coupes standards par contre sert bien sur les coupes de biais.

Bralem na wlasne potrzeby.Bardzo fajna maszynka. Testowana na plytkach 60x60