Kundeanmeldelser for VEVOR Tilhengerjekk med hjul, 907 kg lastekapasitet, kraftig svingbar båthengerjekk med dobbelthjul i PP og ergonomisk håndtak, løfteområde 381–685 mm, egnet for bobiler, båter og nyttehengere

I am very pleased with the trailer jack I ordered. Only took a few minutes to install and it works great. For year I have been hauling a cinder block every where I went to use as a trailer jack. I can't believe how much aggravation 60 dollars saves me.

Excellent product and high quality. Its price is very affordable. Quality and price is a good reason to continue shopping with you.

Very well built and sturdy. Completely satisfied. Used on our 21 ft boat trailer that weighs 4200 lbs. Easy to use and makes moving our boat around easy

Bonjour, Jai monté la roue jockey sans problème. Elle parait de bonne facture et c'est l'utilisation dans le temps qui me permettra de juger de la fiabilité !!!!. En charge la roulette a du mal à pivoter . J'aimerais avoir une réponse à ce sujet. Seule remarque : Même si je me débrouille en anglais, je pense que la doc pourrait être traduite en anglais !!!!!

Facile à monter et robuste mais manque un réglage Pour la hauteur

alles bestens

It works as it should

Product has a lot of slop in the swing mechanism and had a pea size amount of grease on the cap and zero on the actual gears of the mechanism. Make sure to check yours before use. Over all it seems to be of decent construction. I will update after 6months.

I bought this to put 2nd jack onto my trailer so I could jack it up higher and use both to block under each other as i raise it to drain boat better when it sits. The pipe is longer than the one on it now. I had hoped it would have more lift. It does not extend as fully within pipe as it would seem it should. But it seems strong and good quality so I moved it rearward more and since I'm blocking each using the other for lifting sequentially it just means I need more blocks and time. I have a 6000 lb tandem axle aluminum bunk trailer. The jack has predrilled holes in the bars and plate it mates to that you clamp around trailer frame. I rotated plate 90 degrees to see if both sides were spaced to reach and only one side was long enough. But the set of holes has about 1/4 inch gap below bolts on frame so I will need to shim it with something as now it leans badly and is not straight up, causing tension on the pipe that may break it. But I will find some aluminum plate or similar and shim the gap and I expect this to work well, especially for the price. It would be nice if jacks came pre greased-this one feels like it doesn't have any, like all the other ones I've purchased elsewhere over the years. It makes it much easier to crank and protects from rush inside-so take plastic cap off and grease the gear contact points and you will be good to go. I may drill and tape for a grease zerk to use grease gun in future.

My husband didnt quite get this part correct. He ordered this way bigger then needed. The product itself is great.