Kundeanmeldelser for VEVOR Undermonterte Skuffeskinner, 32 Tommer, Full Uttrekkbare Kulelager Under Trappeskapskinner, 260 LB Lastekapasitet Kraftige Bunntrappeskapskinner Skinneløpere, For Gjør-det-selv Utskifting, Svart

Fanno benissimo il loro lavoro, solo che pesano un pò

Adapté à mes attentes, rapport qualité/prix top. Attention pas de clips pour démontage facile. Elles sont fixes.

The slide is heavy and robust. Good for use with heavy load

Parfaitement adapté à mon utilisation, l'extension totale permet de sortir totalement les 2 tiroirs. Leur accès en est donc très aisé.

Great quality for the price. Installation was a little tricky, but I think that was due to an unlevel floor.

Le produit est simple, sans frein mais avec une butée silencieuse. Légère résistance à l'utilisation à la différence d'un casserolier de cuisine. Coulisse bien tout de même et au final cela s'avère utile pour éviter une fin de course brutale. Montage facile mais attention la glissière ne se démonte pas donc il faut garder un accès pour visser au sol. Reste à voir l'usure dans le temps mais je suis confiant car le produit semble robuste.

Very sturdy and quality build. Could've been better if soft close was added but not necessary though. o

bon produit, manque un peu de fluidité dans le coulissement, faire attention au poids supporté

Está muy bien, pesa mucho pero teniendo en cuenta lo robusto y grande que es merece la pena sin duda.

These slides weigh quite a bit and made of sold steel construction. While there are ball bearing, I wish that they would slide more freely. This was the case before and after installation, so it didn’t have to do with the slides not being installed parallel to one another. Finally, it may be impossible to install the slides based on the information provided as there may not be enough space to squeeze behind the drawer to secure the slides to the base plate. Some ingenuity is required here. I constructed my drawers such that it was held entirely with pocket screws, no glue was used. The bottom of the drawer was attached to the slides which was secured to the base plate first. Afterwards, the sides, front, and back were attached to the bottom and then secured with screws. Those pieces had dados to accept the bottom piece. The only requirement is that the back of the drawer extends a few inches away from the wall so that you can get your arm in there with a screwdriver to attach the back piece of the drawer. I hope this review helps somebody. I almost had to return these and go with side mounted slides.