New

VEVOR Electric Tube Bending Machine, 750W Electric Tubing Bender with 6L Hydraulic Cylinder, Movable Pipe Bender Machine with 3 Dies & 180° Max Bending Angle, Suitable for 25.4mm, 38.2mm, 42mm Pipes

read full review before buying we had to do a lot of mods My shop bends about 30-50 tubes a day with offsets, kicks and 90’s from 1/4” to 1 1/2”. now this bender does bend fast and the auto setting is decent. Our struggles with this bender is 1: the frame is very wide compared to our other benders. If you have very close 90’s you will have to reverse bend every time. 2: The die clamp that holds the tubing down while bending, some of them don’t fit and you have to modify them by re-welding them. 3: The die clamps that hold the tubes if it is too big and not snug that will effect your degree bends, in some instances by 20 degrees 4: There are cheap contractor coils inside the cabinet that will arch every time you start a bend once. 5: All Bending dies Have “no markings “ on them so you will have to mark you 0, 15, 30, 45, 60, exc… 6: This bender does feed tubes in from the left side so if your used to the standard right to left feed you will need to adjust. 7:frame with dies are 600 pounds. very heavy we put wheels on ours. 8: this bender is 3 phase 220v make sure you have it or you will need a cps or vfd phase shifter from vevor 9: we run ours of shop 220 and off a generator when traveling with the cps phase shifter.

I've had issues with the foot pedal controller. It hasn't worked since day one. I've reached out to whoever over two month. Period and still haven't had no resolution.