Kundeanmeldelser for VEVOR hoggesag 14 tommers gjæringskappesag for skjæring av metall tørrkappsag 45° vinkel

Cheap and cheerful, but be very careful with the blade. I like the fact that the clamp pivots both + and - 45°

Works great, Good price

works good for the price. Not as accurate at 90 degrees as it could be but not too bad, does not cut thick material very good. even with that it does better than abrasive wheels

Works great for my needs. The only negative i have at this time is that 0° is a little off.

The Item work's good, but it has no option of consolidating it at the stand

This is a good deal at the price point. After using abrasive cutoff saws for 40 years , I figured I would move up in life, while I am still able to use a chop saw. It does ramp up the speed, but who is in a hurry? The few cuts I have made were quite a bit less messy than the abrasive saws.

Worked well for cutting re-bar. Well engineered, reasonably study. Respectable machine for a reasonable price. I have been happy with Vevor brand in the past.

I cant believe this saw is so good,i had a one off job that was going to need many many cuts and wasnt looking forward to all the dust noise and sparks from my ancient abrasive saw so lashed out and bought this one,boy its changed my home DIY life forever,you do have to check its square on the 90 degree and 45 I use a little square to set any angles on any saw anyway,never trust the marks on the saw!check the blade is tight first aswell,i got rid of the quick angle adjusting lever and just use a normal bolt,much better and secure,great saw at a great price,itll last me years.

The item was delivered quickly and was undamaged. It works extremely well and cuts through steel like butter, there are no sparks and the cut leaves no burrs. The only thing I don’t like about it is the clamping mechanism, it’s made of thin material and does not hold the metal being cut firmly. It’s a shame as the other parts of the saw are good quality and work beautifully.

The Vevor 14” chop saw is excellent value and cuts as expected. One small thing - the work top is hollow (about 1.5mm). Thus short cutoffs are not cut at 90 degrees vertically. A shim under the stock is my workaround. This is a common fault with this type of device. Adjustable support under the plate could be a solution. Cheers Don.