Kundeanmeldelser for VEVOR 3-kjevs dreiebenkchuck, 6 tommer (160 mm), selvsentrerende chuck med 1 1/2 tommer-8 gjenget støtteplate, 0,12-5,71 tommer (3-145 mm) spennområde med T-nøkkelskruer, HT300-materiale, for tre- og metalldreiebenk

6 Jaw chuck did fit my lathe with camlock D1-4. It came so dirty and didn't like to move smooth. Had to take it apart, clean every part. Debur it, rework it. Grease and oil. Cut down the plastic back plate because it was touching the gears. Took me 2 hours. Now it is a good chuck with 0.05mm runout

The chuck is at a excellent price point but the quality lets it down some what it had to be completely disassembled and de-burred and washed out to remove grinding particles. Once that was done and reassembled correctly all is good and I look forward to many years of use.

Am verry happy, and pleased Witherspoon it.thank you.

well made, a few nicks needed to be stoned out. would have been nice if the back plate bolt holes were counter sunk.

Bonne qualité du produit point faible mauvais ajustement des tripodes et manque de graisse

I am an amateur, home shop machinist. I bought this chuck with the back plate and shipping included for less than $125.00, an outstanding value IMHO. The two-piece jaw configuration was a requirement and the source of some problems that may or may not affect your decision to purchase this chuck. If you purchase this chuck, be prepared to disassemble it and thoroughly clean and lubricate it. This one was FILTHY, but I expected it would be. After cleaning, a precision 0.5000 pin ran within 0.0020" TIR. , well within spec. I trued the back plate mounted on my lathe spindle (70-year-old South Bend 9-A) and turned the register boss to 0.0050" smaller than the register recess in the chuck body. The test pin repeats within 0.00050 after assembly and adjustment. Amazing IMHO! I removed the top jaws and cleaned the interfaces with the jaw base. Upon reassembly, I could not get the chuck adjusted any better than 0.015" TIR. I reground the key slot so the top jaws would actually seat properly. I will regrind the jaw faces under clamping load with a tool post grinder when I get time. In the meantime, I'm using machinable steel top jaws to hold some 2" diameter steel discs for turning, facing and boring on both faces. The chuck repeats within 0.00050" TIR with this configuration. Again, amazing. I would purchase this item again but only if I had time to do the aforementioned rework.

Very good tool, runout was only .002 thousandth installed out of box. Very good for what I use it for. Neighbor bought a 4 inch to expand centrifugal clutches , I had to machine jaws thinner for unique tool use. The 4 inch was so nice it caught my attention so I ordered a 6 inch to put on one of my small lathes.

Muy buen tiempo de entrega

If you fully disassemble and thoroughly clean it, it can be well worth the price. Depending on the normal size of your work is, it may require boring or grinding. After cleaning, mine had .009-.017” runout. After grinding it, I was able to bring that to .002”. Keep in mind, where you grind it will be where diameter is most accurate and tightening it in the same consistent manner will provide the most consistent results.

Quite happy with this chuck. It seem's to be of quite good quality! Excellet product for price!