Kundeanmeldelser for VEVOR 3-punkts tilhengerfeste med 50,8 mm mottaker, 3-punkts hurtigkobling med tilhengerkule, traktordragadapter for kategori 1, Kubota, Mahindra, Ford, Yanmar, John Deere, Massey Ferguson

Brukeren la ikke igjen noen skriftlige kommentarer.

Jeg fikk ikke beskjed på sms, som er standard varsling, om at tilhengerfestet var kommet fram, så Posten-Bring har returnert varen, uten at jeg fikk varselet. Bring hadde sendt et epostvarsel og Posten hadde varslet via app. Så jeg kan dessverre ikke kommentere varen, da vi dessverre har fraktselskap, som ikke bruker tradisjonell varsling.

First time I used the 3pt trailer hitch to lift my equipment trailer it opened up like a sardine can and dropped my load. The manufacturer used two thin layers of metal mig welded together and thought this was sufficient. Bad engineering and unsafe as well.

I can't believe the manufacturer would allow this quality of workmanship. Every weld on this hitch looks like it was the first time the person ever stuck an arc. Poor penetration, incomplete welds leaving voids where rust stared immediately. Very disappointed with this product. I figure I paid approx. $110.00 for receiver hitch with 3 balls and a hook. would not recommend this to anyone.

Disappointed. I have a quick hit hitch on my 3 point for my chipper and land plane. This hitch does NOT fit a quick hitch, which is very disappointing. Do not buy if you plan on using with a cat 1 quick hitch. I should have read all the reviews, the last review described the problem.

à la première utilisation pour travaux léger le frame c'est tordu avec une petite racine de +/- 1/4 de pouce. Ne pas acheter....

Dont buy from them they dont have a good customer service and this is more than 15 days back and infront and they are not resposing back and they are not accepting there product and they dont accept the returns this is there mistake they send wrong product its not fitthing in my kubota and i alredy ask them

Hi, your product was made too narrow for the three point linkage, the top link was too tight to take a Top link, the welding was very poor on the linkage. So all in all it was a very poor equipment.

Product (3-point receiver hitch) looks well made but do NOT buy if you expect to use on a John Deere iMatch quick hitch. Contrary to the AI question in Q&A section, it will NOT fit - too narrow to fit into lower pin slots. Without the iMatch quick hitch I expect it would work fine. Had to send mine back.

Come da attese