Kundeanmeldelser for VEVOR 52cc bensindrevet T-stolpedriver, 2-taktsmotor bensindrevet gjerdepælemaskin, 1400W bærbar pæledriver med 3-stolpe drivhode (49/69/100 mm), for gårdsgjerder, ranchgjerder, veiforbedringer

This tool saved me many hours of work, and I really could not have done this job without the post driver. I used it to drive 2x6 boards into the ground in front of a lake wall to seal the areas undercut by the lake eroding the soil under the original wall. I tried driving these boards in using a sledge hammer into a heavy clay soil (lake bottom) and was only able to get 8" deep. The post driver was able to get to an average depth of 15 inches. I made an adapter (on 2nd board from right in the picture) to connect the driver to the boards. Like other have noted, using the low speed, just a bit above idle worked best. And when it reaches a point where no further progress can be made, stop to avoid breaking the tool or your work. It is slow but steady. Super easy starting.

used this to drive Lifetime Steel Posts. "How did you a 4" wide post firnin a 3.94" hole?" you might ask. we compressed the post slightly across.the width using 2.5" 5/16" bolts in the top two holes. worked like a champ! and this machine starts with the lightest pull I have EVER seen. it is amazing.

drives post pretty good the collar piece completely stinks, have to stop every 45 seconds to tighten the 4 bolts on the collar and after driving 17 post it completely wallered out the bolt holes. Need a better design for the collar or make it a solid unit that does not remove. driving 2 7/8 drill stem pipe. would be awesome if only used for t post. pipe being driven into sandy loam and red clay.

Después de unas 20 horas trabajando bien se rompió una pieza. Estoy intentando pedirla y no tengo respuesta. La pieza es el tubo Interior dnd va el vástago que golpea.

I bought this as a back up to my titan PGD 3825, which is getting old, for drill pipe. This product is not strong enough, and the machine smocks sometimes. I created a ticket on 04/18, and I am getting the run around to return this machine. All I need to do is return this and get a machine that works. If they have a better one this works, I can exchange . After sending 3 emails fasting for a return label, this morning I got an email with a video on hoe to warm up the engine. How does that help in this situation

This broke after using it on 10 wooden posts 1.5" square being driven into dirt. Think about that, the metal driver broke in half trying to hammer a soft material into a softer material. I emailed for a warranty replacement assuming it was just some kind of production defect. Took 3 days to get the first response. Now, after 11 days of very slow back and forth with " customer service" I'm so fed up with this whole mess that I don't even want a replacement tool and I won't be dealing with vevor again.

Post driver screws will not hold. Completely strip out of the housing not holding stable. 6 screws stripped inside the tube housing. Have been emailing vevor with warranty which I have also bought extra warranty and all they say is I'm going to send you a video of how to glue the screws. They have been saying that for a week now and still not even a video. They also only replay once at night every day with different people with no solutions. I rely back immediately and still no reply for 24 hours. Do not buy any products from them they do not do any warranties and do not help in any good time frame. I have only been able to put up half the poles and now not able to finsh.

On third post the striking face broke. Was really excited to use, but highly let down. I would not recommend this fence post driver. I will be contacting VEVOR for a replacement. We will see how their customer service is.