Kundeanmeldelser for VEVOR aluminiumsmarkise 40 x 42 tommer, slitesterk vindusmarkise dørbaldakin, lette og stabile utvendige aluminiumsmarkiser regn snø sollysbeskyttelse for dørinngangsvinduer terrasse veranda

Good awning, only down side was the anchors it came with where not the best and seemed cheap so I just went and got better ones, the crimps to slide the prices into eachother are not 100% so you have to really beat them into each other. The biggest down side was the plastic coating on the panels! Taking it off was TERRIBLE. Took about 2 hours to take it all off and still was small areas I was not able to get 100% off. That part really needs worked/ looked at.

The canopy is badly designed. It is sagging at the center, even with the brackets already very tight to the reinforced wall. The metal screws provided were the wrong size and head shape. I was planning to take it down and return it but I already invested lots of labor time and purchased different screws. I will monitor over the winter how it performs with snow on top of it. I don't recommend this [product!

awning itself is good and feels well made but the supplied wall anchors not compatible with instructions.... said to drill 12mm hole for concrete/brick but tightened metal anchors still pulled out easily by hand... think you'd need 10mm ones. fortunately there were plastic plugs as well that worked but still not ideal and wasted over an hour of time lifting and balancing the thing to screw it in, for it to not work.

I ordered 6 of the 108 inch awnings to act as a rain deflector on my 53 ft long cottage. It will be the perfect solution to my water problems on the side of the cottage due to a too short overhang design. Gutters were not a possibility due to the design. While the awnings are easy to assemble and will be plenty strong there is a major shortcoming. ALL the roof panels , 8 in this case per section, are covered in a very thin plastic film that is intended to protect the surface paint. It doesn't protect at all ,as most panels have scratches. It is adhered to the panel with a strong adhesive and because it is so thin it tears and becomes a major trial of patience to remove it. It took two of use and hour to strip the sheet off of one section. I have 40 more panels! I don't know what design engineer specified this film but he should be fired. A horrendous experience. I do not recommend this product unless you have absolutely no other solution, and you only buy one. Some of the weld of the frame were over welded and had to be ground down to fit the next piece. If they had not put the film and just used paper to protect it , it would have done just as good a job and i would recommend this product and given it a 5 star ease of use review.

We ordered 2ea 56”x24” metal awnings, we installed the 1st one no problem other than we thought it looked too narrow? We then opened the 2nd one to install and notice it was a foot wider and actually the correct window awning we ordered, they charged us for 2 of the wider units but sent 1 correct and 1 smaller (44” wide) incorrect but charged us for both of the wider units. We like the items and want to order more but are concerned we may get the wrong size again. BOTH boxes were factory sealed and not opened and re sealed. PS: 54” awnings have 5 panels, 44” only have 4 panels.

Holding of middle strip (at slope) with nuts put too much pressure and after couple of days, nuts broke and middle strip came out from one end. I need to put more nuts even there are no holes (from manufacturer) to support middle strip. Installation is extremely cumbersome in addition.

This thing is alright, but very awkward to install. I has to be completely put together and then installed on the wall. It takes 3 guys to put it up. It should be able to build modular while it is hung and leveled. The screws are never tighten , they just keep turning. The metal is thin and cheap. I had to add several good metal screws to fix it.