Kundeanmeldelser for VEVOR motorsagmølle, bærbart sagbruk 14"-48" sverd, galvanisert stål motorsagplankverk med 0,2"-11,81" skjæretykkelse, tretømmerskjæringssagverk for byggherrer og trearbeidere

I replaced all bolts, washers and replaced the nuts with nylock. I need to trust a chainsaw bolted across my belly. The assembly instructions could have been better and even with the video it was quite alot to get right. Finally there was two mystery bolts where the chainsaw guide bar should be inserted and since i wanted to get it right i asked support. They arent that supportive.. and its been like two weeks already and i havent gotten a stright answer. The support dont seem to understand the mechanics of the sawmill AT ALL. I had to drop one star because of this. Never talk if you dont know what you are talking about, just ask someone smarter. Bottom line. This is a sweet deal compared to "the original" and that compensates for halfass support.

Das genaue einstellen der Schnittbreite erfordert schon recht viel Zeit. DIe Skalen sind nicht wirklich zu gebrauchen. Aber es sind gerade Schnitte möglich.

Hyffsat stark men delvis svårstartad och drar endel bränsle

J'ai dû faire des modifs pour que ça fonctionne correctement et la visserie est moyenne

Be prepared to reinforce the tubes that clamp to your chainsaw bar. If you don't, and you tighten them enough to actually hold the mill together in use, you will bend the tubes and render the entire tool pretty useless in minutes. I pressed aluminum bar stock into the ends of all 4 clamp tubes and drilled clearance holes through for the bolts...and thing shave worked just fine through many dozens of oak slabs. The whole thing should have been built with beefier tubing, like the granberg stuff they tried to copy..... If you aren't handy enough or don't have time to reinforce this thing then you're just wasting your money. But if you can tune it up it will get you where you want to go.