Kundeanmeldelser for VEVOR hydraulisk, 12 tonns H-ramme gulv, stempler, justerbar arbeidsbordhøyde for bøying eller retting av metall, garasjer eller boligverkstedpresse, oransje

did not get it at the time they said

It's ok. I Kinda expected more out of it. I suggest you go for the bigger press they offer.

The price was right and the quality decent. That said, I am in the process of implementing a few upgrades to make it even better. (1) Raising the press up about 16" so my 6'-5" frame does not have to bend over. (2) Stiffening the new base to eliminate any twisting or other motion. (3) replace the 12T jack with a 20T pneumatic unit from Vevor. (4) Building a new set of press plates out of 1" stock. (5) Beefing up the frame, etc. as it becomes necessary. This is very similar to another well known company who ships their FREIGHT made in China to US HARBORs. I am hoping it holds up well to the medium duty use I intend to use it for.

The press works well. Easy to assemble. Easy to use. One strong suggestion: Add two “sleeves” to the kit. They should be installed on the two bolts that go through the Rest that the item being pressed lays on. They should hold the two channels apart to ease movement Of the rest up or down. Without the “sleeves”. The rest is clamped in place restricting movement. The support pins should be adequate to hold any down pressure applied to the rests.

A bit difficult to square up. Use it to laminate various hardwoods plies for turning stock.

overall it does the job. it is not balanced, the holes for the legs leave it side ways, if you can correct that so its leveled you will be solid.

Man får det man betalar för men den gör sitt jobb. Kunde varit bättre infästning för själva hydrauliska kolven.

Bonjour J'ai Besoin de ma facture SVP merci d'avance Bien cordialement POISSONNERIE BATTEUX [email protected]

Not as heavy duty as I'd like, but will press my light duty stuff. Would be afraid to do anything larger on it.

The press was rather easy to assemble. The only drawback is it takes 2 people to install the jack. The 2 other drawbacks is the table part needs a sleeve between the bolts If you tighten them you can't move the table without loosing the bolts. I just cut a couple pieces of round tube and made sleeves. The other drawback is the press plates. Unlike the plates on the harbor freight plates which are 1 inch thick and have different notches on all 4 sides this press has just 2 thin flat plates. Making it difficult to press different types of bearings etc. Other than that it's worth the money.