Kundeanmeldelser for VEVOR hydraulisk rørkrympeverktøy, multifunksjonell rørfittingskrimper med TH16 TH20 TH26 TH32 kjever for PEX- og aluminiums-plastrør, og V12 V15 V18 V22 V28 kjever for rustfritt stålrør

Razoável

This thing is amazing. Almost as fast as electric/battery operated. I gave it 4 stars instead of 5 because it's too bulky to press tees, but it has already saved me time and money by not having to solder. And for only around $100. It was a great purchase on my part.

Works great Construction is good Would recommend it

Works well for everything except Tee fittings. The jaws are physically too big to crimp the middle branch on a tee. Works fine everywhere else.

Lo he utilizado en tres ocasiones, cumple con su función, echo en falta un manómetro para grimpar siempre a la misma presión pero por lo q vale es correcto. Si vas a darle un uso intensivo creo q no aguanta mas de un mes..

Good low-cost crimp tool for Propress fittings and PEX clamps

Nem találtam a honlapon kiegészítőleg megvásárolható U típusú prés fejét. A hidraulikus prés nem elég errőren nyomja össze az idomok.

Easy to use generally, the weight and the wrap around approach makes it hard to use in tight spaces. You need to be mindful of space between the pipework and the wall to be able to crimp a connection. Also be careful since the weight can cause unwanted slip in the press fitting and always double check the inspection holes in the connector before tightening it. Other than that i was able to crimp around 30 fittings without issues.

I did a test run press fitting pipe to fittings to get the hang of it. On my first attempts at 3/4 pipe replacement lieaked. I hadn’t pushed the arms till they made contact with each other I contacted Vevor to see if I could repress the installed fittings they said problem. I then using full strength repressed them no leaked a month later and the joints look clean. I’m in 60’s and needed to use 75% strength.

Great for pres together plumbing projects, as long as you’re working out in the open, water heaters, etc.. if you need to put something together in a tighter space though, you can’t get the mouth of the tool over the top to lock in place to make your crimp, could possibly be engineered more like the cordless propress where you can clamp on like polars from two sides instead of having to go over the top to lock in