Kundeanmeldelser for VEVOR kjøttskjæremaskinblad, 5 mm erstatningsblad for kommersielt bruk for modell 90 matskjærer, rustfritt stål, for benfritt kjøtt, myke grønnsaker
Kunde anmeldelser
Hvordan kundeanmeldelser og -vurderinger fungerer
Kundeanmeldelser, inkludert produktstjernevurderinger, hjelper kunder med å lære mer om produktet og avgjøre om det er det rette produktet for dem.
Den samlede vurderingen vår er ikke et enkelt gjennomsnitt. Vi prioriterer autentiske og troverdige anmeldelser og filtrerer ut duplikater eller ugyldig innhold før vi beregner den endelige poengsummen. Dette bidrar til å sikre at vurderingen virkelig gjenspeiler reelle kundeopplevelser.
Anmeld dette produktet
Del tankene dine med andre kunder
Skriv en anmeldelse
3 Anmeldelser
Anmeldelser for Gjeldende Produkt
Verifisert kjøp
Bilder og video kun
Oversett alle anmeldelser til Norsk (Berkmel)
plopezmeats Very good
Works well
0 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
Blade pack Better
The original 3.5mm blade pack that came with the meat slicer was basically junk. This replacement model was much better. The spacers between the circular blades on the original were some kind of plastic or nylon. They came loose and the blades would stop even though the motor would still run. The replacement blade 5mm pack seems to use metal spacers so probably much more clamping force between blades. No problem with this one so far. I have made a jig and tried tightening the nuts on the old blade pack.. Don’t know if it worked yet I still need to try it out.
0 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
Adam mr
Seems to work well. I had issues with the blades stopping while running. It turns out the blades are held in there just by compression, nothing physically connected to the shaft turning the blades. To fix this issue you need to tighten the nut on the assembly. This can be complicated by the opposite side is round with a notch. I am making a custom tool to hold the round side, but you can set it up with a flathead screwdriver. Just be very careful, the blades are extremely shart. I also wish there was a storage box for these from factory. I ended up 3D printing a custom storage box for these.
0 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
