Kundeanmeldelser for VEVOR mekanisk nøkkelfri inngangsdørlås, 14-sifret tastatur, dørlåssett for utendørs port med overflatemontert lås, vanntett sinklegering, tastatur og knott, enkel å installere, for hage, gårdsplass, garasje

Bra och enkelt mekaniskt kodlås

Paarfait

Poignée super, facile a programmer et à poser

Recomand cu încredere . Ușor de montat, fiabile și sigure.

POLECAM

POLECAM

Ich habe das VEVOR Codeschloss bei mir zu Hause installiert, und es funktioniert absolut einwandfrei. Die Bedienung ist zuverlässig, der Code lässt sich leicht einstellen, und die automatische Verriegelung ist sehr praktisch. Ich bin wirklich zufrieden und werde das Schloss definitiv noch einmal kaufen.

Serrure à code Mécanique parfaitement conforme. Seul petit inconvénients, il faut démonter la serrure pour changer le code (5 minutes).

Nice looking unit, easy install with clear instructions and all necessary hardware included. My installation was a bit unorthodox in that I installed it on the side post rather than the door, using one of the plastic base mats as the door stop. Suits my needs and is easy to use with the option to set an ‘always open’ mode or switch it back to the ‘code to open’ mode. Time will tell how it performs in the outdoor position with corrosion resistance. .

For my garage, this is a good substitute for a standard locking set as I no longer need to fetch a key every time I need access. The cost is reasonable and I will never worry about dead batteries. So far, it is working well for my purpose. However, there are some things to be aware of: 1. The code combinations are limited because you can only use each alphanumeric once, and; 2. The order of the code entry seemingly doesn’t matter. 3.. The instructions for changing the code are accurate but the indicator marks can be difficult to make out under poor lighting (or with old eyes), so make sure you “play” with it outside of the door until you are 100% happy with the way it works before you install it. 4. The bezel width just very barely covers an exiting hole for a standard North American lockset, which can make installation finicky on an existing door. You may even need to infill the old lockset hole with a round plug before drilling new holes for this unit. So, for a new door with no pre-existing hole, this would go much more smoothly than for a retrofit, I suspect. It would be nice if the kit included an infill plug for old doors, and maybe a slightly wider bezel for a bit more coverage of old holes. And if you have your heart set on a specific code, be prepared to make compromises. Finally, if your door has a standard rectangular window with plastic trim, there could be some interference with the bezel. I had to trim the plastic molding slightly along the bottom corner to allow the new mechanical unit to fit properly.