Kundeanmeldelser for VEVOR Metalldreiebenk Minidreiebenk 220x750mm Metalldreiebenk 750 W Minidreiebenk for metallbearbeiding som dreiing, boring, gjengeskjæring og skjæring

Great "Looking Lathe" however after setting it in place, degreased and lubricated the gearing and track, went to plug it in, (110V Standard US plug... ) Keep in mind we are a full machine shop and this was specifically for smaller items the CNC Lathe is too big for. In the US, we assume the green button means go so we push it with anticipation of the magic happening and POOF, electrical fire, smoke and then nothing... this is the second large ticket item we've tried with VEVOR the first was a three phase converter... same issue and still have not received refund for that one either

Headstock tilted down .017 and out. All dovetails had to be remachined and scraped it. Grease and metal dust between all surfaces. This thing couldn’t cut much less hold the tolerances specified. I bought specifically for 32 tpi (listed) yet it will not cut 32 tpi bc it doesn’t come with the gears and isn’t listed in the manual as cutting 32tpi. Which is the whole reason I bout it. Now I have to figure out and purchase gears that should’ve been provided. Not only that. Imperial threads aren approximate and not exact. So it will bond if thread engagement is too long. I used a surface plate and a test indicator and my god nothing was even close to flat and parallel.

Bij levering een kapotte aandrijfsnaar - werd wel een nieuwe aangeleverd na reclame Na ongeveer drie uur draaien brak tandwielset uit huis van de dwarsinstelling - is nog onder beoordeling van Vevor - maar beloofd niet veel goeds Chat(robot) onbruikbaar, beter direct met [email protected] contacten.

Received lathe was packaged well. Got it setup only to find out that it would not even power on. All moving parts very sloppy in tolerances