Kundeanmeldelser for VEVOR Arbeidsbord for fresemaskin, kryssglidebord, 10,2 x 18,5 cm, fiberforbindelse for benkboreskrustikke

Redelijk apparaat, Chinese kwaliteit. Nonius is niet te gebruiken. Niet geschikt voor nauwkeurig werken. Hier was de prijs ook naar.

I needed to drill a cirlcle of holes on my drill press. This was used in conjunction with a Vevor 4 inch rotary table. I had to disassemble this prior to use as the anchor for the Y axis thread dropped out of its location and jammed the table. Drilling and tapping a thread to hold a large body washer may fix this. While you’re down there …..i cleaned everything and lubed the parts with teflon spray.. The Y axis gibs are inconsistent - snug in one position, jammed tight further along its travel. I back them out, get it where I want it and lock them down.

No esta mal contruida pero es algo tosca y dura. Hay que ajustarla y limpiarla, No tiene un manejo facil.

Produits à modifier avant utilisation, inversion d'un des réglages de table sans cela la manette est dans la poutre de la machine, pas mal de bavure en enlever, malgré les réglages d'ajustement des guides,des points dur sont présents avec une légère ondulations lors de l'utilisation......

A set of 10x26x8 bearings ,a few shims and a lot of clean up made this milling table surprisingly good. If you are willing to put in the time you can't find a better table for this price. The fitment of the bearings needed a little machine work on the bearing pockets but other than that it was mostly clean up work. Polished the Gibbs and removed all the stray paint. I got mine on sale for about 60 something dollars and I feel like I stole it.

Degelijk apparaat, maar schaalverdeling is niet te lezen,veel speling in de spindels,

Après démontage de celle ci pour retirer les traces de peinture, de rouille superficielles, graissage des guides, fabrication et remplacement de clavettes de toupies pour retirer le jeu, et ajustage de l’ensemble, il est possible de l’utiliser utilement.

Overall it is decent. The casting quality of the bed is pretty rough as stated in other reviews. In order to get T-Slot hardware in the slots took a couple hours of grinding and clean up.

Not as stable as I'd like it to be.

This seems overall OK as a starting point but it will be a project to get it good enough for milling. For drilling it is much more convenient then re-clamping and good enough for many jobs.