Kundeanmeldelser for VEVOR Motorsykkel Avtakbart Hjul Dekk Kloss Nest Vugge Justerbar Universal

It's a little wide, it does create a tripping hazard.

Overall, the product is solidly constructed but tolerance between the backstop and pivot plate with the base plate is pretty sloppy. Pivot to base at the fixing pin has about 10mm of side slop. Between the backstop and base plate at the 12mm fixing pin is about 8mm. Not the end of the earth but the addition of several washers is a must to ensure the bike is held upright without sideways/rocking movement. I had hoped for a portable bike stand to use in my garage with a couple of bikes but slides on concrete so easily due to the short pivot creating a steep ramp to drive onto the stand so Ill need to add rubber pads under the stand for it to do what I need it to do.

For what it is, it does the job. Quality pretty good for the price.

Reçu en temps et en heure mais arrive déjà abîmé avec manque de peinture et un peu piqué part la rouille donc decu

I have a 21", 90 width front wheel which is a little thin for this so doesn't hold the 250kg bike secure enough. I have a simple solution: kick down sidestand, put a little stone under it and done. No wind is strong enough to tip the bike like that. You can check it out on my youtube channel @onthepegs

Bon rapport qualité prix

Decent build quality, cones with the hardware to install , although I used larger washers, handled my KLR650 with ease.Can't complain for the price. Would recommend this unit.

Easy to put together very sturdy I just don't know how hard it's going to be to get the motorcycle back out of it I put it in it haven't taken it out yet but it was a little harder to get in it than my last one but otherwise good quality easy to build

Love everything accept the welds look jenky..

Worked well to support a HD Fatboy in a 6x12 U-haul trailer for 1700+ miles. Tied the fork lowers down to the bar on the stand. Also tied down handlebars to the D-rings for some additional safety measures. Problem came when trying to pull the bike back out of the cradle. Would have worked better if I could have screwed down the stand to the trailer deck, but its a rental. Conversely my CBR600 pulled out of the cradle with no issues, roughly same weight (older bike), so tire diameter, weight distro and all affect the ease of pulling it out.