Kundeanmeldelser for VEVOR Motorsykkelstativ Hjulkloss foran eller ekte dekkstørrelse 15

It's a little wide, it does create a tripping hazard.

Overall, the product is solidly constructed but tolerance between the backstop and pivot plate with the base plate is pretty sloppy. Pivot to base at the fixing pin has about 10mm of side slop. Between the backstop and base plate at the 12mm fixing pin is about 8mm. Not the end of the earth but the addition of several washers is a must to ensure the bike is held upright without sideways/rocking movement. I had hoped for a portable bike stand to use in my garage with a couple of bikes but slides on concrete so easily due to the short pivot creating a steep ramp to drive onto the stand so Ill need to add rubber pads under the stand for it to do what I need it to do.

For what it is, it does the job. Quality pretty good for the price.

Easy to put together very sturdy I just don't know how hard it's going to be to get the motorcycle back out of it I put it in it haven't taken it out yet but it was a little harder to get in it than my last one but otherwise good quality easy to build

Love everything accept the welds look jenky..

Worked well to support a HD Fatboy in a 6x12 U-haul trailer for 1700+ miles. Tied the fork lowers down to the bar on the stand. Also tied down handlebars to the D-rings for some additional safety measures. Problem came when trying to pull the bike back out of the cradle. Would have worked better if I could have screwed down the stand to the trailer deck, but its a rental. Conversely my CBR600 pulled out of the cradle with no issues, roughly same weight (older bike), so tire diameter, weight distro and all affect the ease of pulling it out.

Good Quality material and ver stable. My 430kg bike pushes the stand away instead of rolling into the stand. delivery took 5 days longer than Promised and picked it up from depot otherwise I would have waited another 2-3 days

When you load a motorcycle too much free space on the Axe central front wheel is going left and right approximately 1cm Too heavy 15kg Too big Too expensive for that tand

This chock is well made and a bargain for the price. It makes for a safe and steady brace while you work on your bike.

This wheel chock is of good build quality. There were no instructions included and the hardware was loose in the box. I had to scrounge for nuts bolts pins and washers. I did go together without instructions so maybe not needed. I did not have problems in assembly. I did have to place a thin piece of wood just before and just after the rotating wheel holder to accommodate the weight of a touring Harley Davidson (900+/- lbs.) All in all, I'm satisfied; its stable and it feels secure even without strapping it down. However, safety first!