Kundeanmeldelser for VEVOR Rørbøyer, 1/4" (6,35 mm), 3/8" (9,5 mm), 1/2" (12,7 mm) ytterdiameter, 3-i-1 manuell rørbøyer, 180° bøyeverktøy for kobber- og aluminiumsrør for bilreparasjon, HVAC og klimaanlegg

Der Rohrbieger ist von guter Qualität, sehr gut verarbeiten und es war damit möglich eine 1/2 Zoll Klimaleitung 120 Grad zu biegen. Das ist bei eine Wandstärke von 0,8 mm nicht wirklich einfach ohne das die Leitung knickt. Der Rohrbieger ist perfekt für Klimaleitungen da er für die gängigen Leitungen 1/4 3/8 und 1/2 geeignet ist.

I bought this to bend 1/2" hvac tube. The first practice bend was good, the second through fifth were all kinked! After many more attempts I was able to make 4 double bends with reasonable success. On to my hvac lines... the first bend was going well until about 60 degrees, then it started to kink. I was able to salvage the kink and finish the bend. The second 90 worked OK but had a few larger puckers on the inside. To be honest, the radius of the tool is too tight for 1/2" for consistent success. My best guess is add another inch to the tool and it would be excellent! Now after saying that, the 50' tubing kit that I bought from Vevor was less maliable than the tubing that came with my mini-split AC, and that could be part of the problem. I found that going slow and stopping with less pressure about every 10* seemed to help. The bender is an absolute champ on 1/4" and worked well on a few 3/8" bends I tried.

Ce n'est pas à ce que je m'attendais. Très déçu !

DOES NOTFIT FOR 1/2 INCORECT DISCRIPTION !