Kundeanmeldelser for VEVOR Rørbøyer, 1/4" (6,35 mm), 3/8" (9,5 mm), 1/2" (12,7 mm) ytterdiameter, 3-i-1 manuell rørbøyer, 180° bøyeverktøy for kobber- og aluminiumsrør for bilreparasjon, HVAC og klimaanlegg
Kunde anmeldelser
Hvordan kundeanmeldelser og -vurderinger fungerer
Kundeanmeldelser, inkludert produktstjernevurderinger, hjelper kunder med å lære mer om produktet og avgjøre om det er det rette produktet for dem.
Den samlede vurderingen vår er ikke et enkelt gjennomsnitt. Vi prioriterer autentiske og troverdige anmeldelser og filtrerer ut duplikater eller ugyldig innhold før vi beregner den endelige poengsummen. Dette bidrar til å sikre at vurderingen virkelig gjenspeiler reelle kundeopplevelser.
Anmeld dette produktet
Del tankene dine med andre kunder
Skriv en anmeldelse
1 Anmeldelser
Anmeldelser for Gjeldende Produkt
Verifisert kjøp
Bilder og video kun
Oversett alle anmeldelser til Norsk (Berkmel)
2icebergs Great and not so great
I bought this to bend 1/2" hvac tube. The first practice bend was good, the second through fifth were all kinked! After many more attempts I was able to make 4 double bends with reasonable success. On to my hvac lines... the first bend was going well until about 60 degrees, then it started to kink. I was able to salvage the kink and finish the bend. The second 90 worked OK but had a few larger puckers on the inside. To be honest, the radius of the tool is too tight for 1/2" for consistent success. My best guess is add another inch to the tool and it would be excellent! Now after saying that, the 50' tubing kit that I bought from Vevor was less maliable than the tubing that came with my mini-split AC, and that could be part of the problem. I found that going slow and stopping with less pressure about every 10* seemed to help.
The bender is an absolute champ on 1/4" and worked well on a few 3/8" bends I tried.
5 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
