Kundeanmeldelser for VEVOR bærbar ventilator, 203,2 mm kraftig sylindervifte med 10 m kanalslange, 145 W kraftig verkstedblåser 1020 CFM, industriell blåser for suging av støv, røyk, røyk hjem/arbeidsplass

fonctionne très bien,robuste,top

This thing pulls everything. Use as a fan or Ventilation. It is loud. Mine im being ready to send pics in for a replacement i didn't notice the bolts that hold the guard on had vibrated out (when I get my new one I will lock tight then) and the guard got into the fan blades and broke a blade.

Il fait le job, même si encore insuffisant pour mon activité, il réduit la chaleur de 1 à 1.5°C dans ma brasserie de 160M2 avec un plafond de plus de 5m. Matériel semble solide et assez lourd pour ne pas bouger.

le produit fonctionne bien . je pensse que c'est un bon achat on verra pour sa durée de vie . le seul problème c'est qu'il a été livré en point relais alors que j'ai demandé au domicile, je n'avais pas de moyen pour me déplacer. ( livraison par DPD pas top)

De waaier doet goed zijn best Het product werk heel goed

Works fine, good quality but a speed control would have made it perfect!

get one with a 2 way switch for motor, but they won't disappoint.

The fan itself works very well, and I have been using it for weeks now. The long 10m hose seems to cause too much back pressure, so it does not effectively allow for the air to vent outside. I ended up not using the hose.

Fait son travail, rien à dire,bon produit,solide, rallonge de connexion courte. Sinon je recommande vivement ce produit. Merci

This turned out to be a good purchase. The fan feature works well,, the noise level is right at tolerable if you’re running it in the same location that you’re working in and the room size is a conventional room in a residence. If you’re running the fan on the opposite side of an exterior wall, it’s obviously more tolerable. As far as features, it’s hard to rate higher than a four, because there aren’t any features beyond the on/off switch and the GFCI reset switch. The fan draws enough air to clear smoke and Sheetrock dust effectively, as long as you’re providing enough air for it to move out. The fan is only set up to pull air at the end of the ventilation tubing and NOT PUSH IT, but I did have to utilize it as a push because of environmental circumstances and it performed ok as well with no detectable added strain to the motor. You just need to ensure that you tie the tubing to the fan casing well, because it’s not flanged like the intake, but it does have a rolled edge. I also secured around the guard for the trigger just to be certain it didn’t work itself free and blow the tubing through a window or something. The fan seems to be built well, but there’s not a whole lot of building involved. The casing is steel with rolled edges, intake is flared to connect tubing, functional GFCI switch inline, orange paint that helps with visibility, an on/off switch, removable steel grates on either end to facilitate cleaning and any maintenance or necessary repair, thick plastic fan blade and rubber feet for traction. You should be sure to clean as necessary, especially when you have it moving dust or things of that nature, and I had an old nylon bag that wasn’t being used to throw the tubing into, as well as a small leather belt that I got to run through the tubing and latch to make it easier to carry with the fan. Fan weighs 26.2 lbs carry weight total as I have it set up to travel, and depending on what I’m using it for, I usually keep a 13 gallon trash bag as well to put the vent tubing into until I can get home and rinse out any dust that may have accumulated inside.