Kundeanmeldelser for VEVOR magnetisk drill, 1450 W motor 1,6 tommer borediameter, 2810 lbf bærbar elektrisk magnetborepresse, med 11 kjernebor, 850 o/min hastighet, boremaskin for metalloverflater, hjemmeforbedringsindustrien

La machine a l’air de qualité mais il me manquait le bidon d’huile et son support toujours en attente d’une réponse

The screws get lose easily. Overall quite ok. Made my welding table with this machine.

Fonctionne pour un usage occasionnel. Attention pas de possibilité de régler la vitesse ce qui en fait un inconvénient majeur.

Drill works great. Annular bits are not very good. One (9-16) broke within 2 seconds. 5/8 cutter won’t cut after 3 holes.

I have drilled probably 50,000 holes in my life in the construction industry with a mag drill costing 10 times the price. Vevor makes tools available at a great price to value ratio. So many bits and they seem to cut good. Oil bottle is often in the way when trying to drill holes. It could be secured much better than the current setup. The whole reason for a mag drill is drilling upside down etc. The magnet even on a flat clean surface is not powerful enough in my opinion. On my bench in my garage I hard trouble pulling soft enough on the handle to start the 1/2” hole without the drill skipping sideways across the metal. Once the hole got started it was ok. I tried drilling a hole on the side of my galvanized trailer and the magnet wasn’t strong enough to hold it there even with the drill in the off position. I think this product was rushed to production to quickly. So many areas for improvement.

A única coisa que me incomoda nesta máquina é a temperatura elevada que registei nos 60° mesmo quando não estou a trabalhar com ela pois basta estar ligada a parte electromagnética e ela aquece bastante na minha opinião. Já referi este inconveniente à vevor ainda não recebi uma resposta conclusiva.

Se me a frotó la carcasa negra de arriba y la quería comprar

Voor een enkele licht klus gaat goed

Works well for the occasional mild steel use. Mine works the grub screws loose on the ways which bind the unit up and the magnet is weak if you are drilling anything more than mild steel, Biz and other hard steels lift the drill off the material which ruin the expensive TCT cutters. If the magnet was stronger it would be 5 stars.

Je n'est pas reçu la bonne perceuse VEVOR n’a pas voulu me l’échanger et elle et arrivé endommagé il on rien voulu savoir décevant