Kundeanmeldelser for VEVOR platesaks, 155 mm manuell platesaks, kraftig monteringstype platekutter med solid stålramme, høy presisjon, forlenget håndtak for kutting av stål, kobber, armeringsjern og aluminium

A mesa chegou empenada 1 cm, pelo que o aparelho só se apoia em 3 pés. O vendedor propôs 20€ de compensação e aceitei para não ter o trabalho de reenviar coisa tão pesada. É evidente que não há cuidado, ou conhecimento, por parte de quem soldou a mesa, e como não há qualquer controlo de qualidade, se calha bem, tudo bem, se calha mal chega-nos um produto defeituoso.

Don't buy. Price was tempting. i just got around to using it. See the pics. Anvil and blade don't line up. This thing wouldn't cut cardboard. Either the anvil or the blade will have to be ground down to work. I'm surprised there wasn't any shims to add or subtract. I would expect it to at least work once before I have to fix/modify it.

Tried to cut a 1,5 mm steel plate, but a shear pin inside broke iand it is now unusable. But it was good for cutting aluminum plates and easy to cut round shapes. Have tried to replace the shear pin with a piece of a drillbit, but the material is a bit warped and I will have to use an angle grinder to remove it, but I think it will be possible to use it again. Will only use it for Aluminium in the future since the steel is to soft for proper operation when cutting steel

seems to to be okay on the thinner metals, haven't given it much of a workout yet.

the shear is ok but very hard to use on flat bar

I am afraid to say this is not very good quality used it first time and broke not very robust and engeeniring is of a low quality so not good

Does not want to cut sheet metal it slips a lot

unit will not cut seems the cutter are not aligned properly. I'm requesting a refund.

after about 4 hours of fixing the shear it works good, all bearing holes were stamped out not round . i had to round holes add bearings now it works good . i call this a kit shear