Kundeanmeldelser for VEVOR girjekk 1100 lbs 2-trinns hydraulisk høyløft vertikal teleskopisk

I can’t complain much for the price, but it slowly bleeds pressure off and drops the transmission down slowly, which isn’t good when you’re trying to get a transmission in or out. I’ve had it less than a year.

This looks ideal initially, and with a great price. In reality, its underbuilt, the table it is very floppy, too small, and it doesn't even come close to lifting high enough. Thats the biggest issue. If youre going to use this on a regular car lift, you need a transmission jack that goes up a MINIMUM of 12" higher than these do. If you're only going to use a couple of times, its probably worth it. If you want to use it in an actual shop, get a real jack that goes high enough.

First and foremost the hardware is cheap and cheesy. Secondly the casters are absolutely trash-order good 1k casters when you order the jack, you’ll thank me later. Table is ok’ish side to side is useless and the tilt is super sloppy,and yes they used the same cheesy hardware for the tilt and side to side adjustments. The jack itself works but the ergonomics are more suited for people in the five foot tall range. But it does work-I would hate to use it daily to R&R tranny’s especially if I’m working flat rate commission lol

Unfortunately I've used this thing two times and the cylinder acts up, it is not tall enough I had to make an extension and I'm not a fan that there is no side to side tilt it's only front to back

Well the price is good, but you get what you pay for. The jack doesn't go high enough to work under a lift I can stand up under (I'm 5'10"), If the jack raised up another 6 inches I could work with it better. Now I have only used the jack on one car and the jack is hanging up when you try to let it down. The first stage will come down after a second but it stops when it gets to the second stage and you have to shake the transmission to get it to release and come on down (Kind of dangerous even with the chains secured) also the plate only tilts one way and the other handle just moves the plate front and back (or side to side depending on how you position the plate under the trans.)

I read the comments and did some research. Overall the price is great but Jack does not go high enough and I’m not a tall guy. Going to have to build an extension. The plate works well with an automatic transmission but I will have to fabricate something for standard Transmissions. As the cradle legs are lightweight. Would recommend as far as price as it works well overall.

The company was very difficult to deal with when trying to contact someone to do troubleshooting of the product I purchased

Good product for the price point. The reason for it not getting higher than 3 stars is the cheap quality casters make it difficult to maneuver, and the head unit doesn’t tilt front to back, and side to side like professional jacks.

I purchased this transmission jack for.my shop it works fine but is defective it goes up no problem but it don't want to come back down I can't just ship it back to company so I'm stuck with it and the pad to pump up is very slippery