Kundeanmeldelser for VEVOR girjekk 1100 lbs 2-trinns hydraulisk høyløft vertikal teleskopisk

Got this to replace a transmission in a 69 Mustang. The up and down part works fine but the hold down chains and straps make no sense and there was no directions. It is surprisingly sturdy for the price.

I bought this and used it one time For the price it is worth it although I don’t understand why there is a knob to tilt side to side but not one to tilt front to back? It has the knob but all it does is move it forward and backwards, not tilting up or down. I had to use a pole stand to get the right angle to align the transmission to the motor.

Yes it worked no I won't use it again on a transmission. Lots of play in the screw adjustment, no side to side tilt just front to back, 2 wheels have locks on them and do not around completely they hit the frame. The jack rod while extended will bend it requires keeping a hand on it to make sure it doesn't tip over when doing a 68RFE. Disappointed but not surprised I was able to complete the job

I used it 2x and on the second time it busted a seal where the shaft moves up and down. VEVOR sent me another one out and I haven’t tried it yet but hopefully it holds up better than the other one!

It is hard to get it to go back down like it keeps getting stuck up and won't go own unless you force it to. Should be 100 bucks less for the quality

Assembly was easy even though directions are a little sloppy. The foot pedal operation need improvements. the swivel bed is so-so when I had a 4l60 on the plate. My biggest tiff is the open / close vavle location is in a peculiar location and theyre needs to be improvements o the open/close vavle for precise adjustments

Overall this thing works as intended. The build quality or the ram and legs is good however everything else is lacking. The foot peddle has a bunch of play while jacking it up The platform rocks on top of the jack and I will be welding mine in place. The castors barely roll with anything on it, and the securing chain/anchor is junk. Just use a ratchet strap Instead. In all this will work as intended but you do suffer a bit for buying one so cheap.

They've changed fasteners that don't match the instructions, and the side leg brackets are now held on by lare socket cap screws. Look like you need an M12 hex drive not 100% sure of that as I haven't dug out my set. The casters are metal and will marr and scratch floors. I bought some M12 stem heavy duty poly castors to replace them with. Also would be nice if it had a rubber pad on the jack surface.

Wheel are terrible they don't sweval all the way around the locks are to big and the top i stead of straight up and down there angled but can deal with just really need to change the wheels out make it hard moving around

The top needs to be made a 1/4 turn different. And the table needs to angle 2 ways not 1 .